TMPM382FSFG Toshiba, TMPM382FSFG Datasheet - Page 252

• Manufacturer Part Number: TMPM382FSFG
• Manufacturer: Toshiba

Specifications of TMPM382FSFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 64K
• Rom Type: Flash
• Ram (kbytes): 8K
• Number Of Pins: 64
• Package: QFP(14x14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 1
• I2c/sio (ch): 1
• Uart/sio (ch): 3
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 10
• 16-bit Timer / Counter: 6
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

10 16-bit Multi-purpose Timers (MPTs)
After a command is issued,
counting does not start until
a specified trigger appears
MT0IN
(Signal after
MT0IN
(Signal after
noise eliminated)
noise eliminated)
After a command is issued,
counting does not start until
a specified trigger appears
MTOUT00/10
MTOUT00/10
10.6.14.3
MT0IN pin, the timer starts counting. The counter is cleared and stopped while the MT0IN pin is
driven to the specified clear/stop level.
MPT0OUT0/1 outputs.
mode”.
(Example)
(Example)
If an edge specified with the start edge selection field (MT0IGICR<IGTRGSEL>) appears on the
In trigger start mode, writing a 1 to MT0RUN<MTRUN> is ignored and does not initialize the
Note: For more information on the acceptance of a trigger, see “Trigger start/stop acceptance
Command issue
Command issue
Trigger start mode
Count start
Figure 10-12 Operation in Trigger start mode
TMPM380/M382 - 52 / 87 -
Count stopped
Count start
Count
clear
Count stopped
Count
start
Count
clear
Count stopped
Count start
Count
clear
TMPM380/M382