TPD4123K TOSHIBA Semiconductor CORPORATION, TPD4123K Datasheet - Page 11

• Manufacturer Part Number: TPD4123K
• Description: Toshiba Intelligent Power Device High Voltage Monolithic Silicon Power Ic
• Manufacturer: TOSHIBA Semiconductor CORPORATION

External Parts
Handling precautions
Typical external parts are shown in the following table.
Note 1: The required bootstrap capacitance value varies according to the motor drive conditions. The capacitor is
Note 2: The following formula shows the detection current: I
Note 3: When using this product, adjustment is required in accordance with the use environment. When mounting,
Note 4: The DIAG pin is open drain. If not using the DIAG pin, connect to the GND.
（１） Please control the input signal in the state to which the V
（２） The RS pin connecting the current detection resistor is connected to a comparator in the IC and also
C
1
, C
Part
R
C
C
C
C
R
biased by V
Do not exceed a detection current of 1 A when using this product.
(Please go from the outside in the over current protection.)
place as close to the base of this product leads as possible to improve the ripple and noise elimination.
2
1
4
5
6
7
2
, C
3
the V
functions as a sensor pin for detecting over current. As a result, over voltage caused by a surge
voltage, for example, may destroy the circuit. Accordingly, be careful of handling the IC or of surge
voltage in its application environment.
Note that if the power supply is switched off as described above, this product may be destroyed if
the current regeneration route to the V
disconnected by a relay or similar while the motor is still running.
BB
CC
power supply and the V
0.62 Ω ± 1 % (1 W)
and must be sufficiently derated for it.
25 V/1000 pF
25 V /0.1 μF
25 V/2.2 μF
25 V/10 μF
25 V/1 μF
Typical
5.1 kΩ
CC
V
power supply are not cared about either.
V
REG
V
CC
V
REG
DIAG pull-up resistor
CC
Bootstrap capacitor
Current detection
power supply stability
power supply stability
11
for surge absorber
for surge absorber
Purpose
BB
O
= V
power supply is blocked when the V
R
÷ R
1
(For V
CC
voltage is steady. Both of the order of
R
Remarks
(Note 1)
(Note 2)
(Note 3)
(Note 3)
(Note 3)
(Note 3)
(Note 4)
= 0.5 V)
TPD4123K
2008-05-14
BB
line is