MT9300 Mitel Networks Corporation, MT9300 Datasheet - Page 3

• Manufacturer Part Number: MT9300
• Description: Multi-channel Voice Echo CANceller
• Manufacturer: Mitel Networks Corporation

Advance Information
Pin Description (continued)
94 to 97, 99 to102,
39 to 42, 60 to 62,
82 to 86, 88 to 92,
28 to 31, 33 to 36,
137, 150,151,160
44, 45,46, 47,49,
50, 51,52,54, 55,
64 to 75, 78, 80,
125 to 132, 136,
18, 19, 20, 21,
3 to 7, 14 to 16,
23, 24, 25, 26
104, 123,
Pin #
105
106
107
109
110
111
112
10
11
12
13
56
9
A0 - A10 Address A0 to A10 (Input). These inputs provide the A10 - A0 address lines to
D0 - D3,
D4 - D7
Name
ODE
Rout
Sout
R/W
DTA
IRQ
Rin
C4i
NC
DS
CS
Sin
F0i
No connection. These pins must be left open for normal operation.
Interrupt Request (Open Drain Output). This output goes low when an interrupt
occurs in any channel. IRQ returns high when all the interrupts have been read
from the Interrupt FIFO Register. A pull-up resistor (1K typical) is required at this
output.
Data Strobe (Input). This active low input works in conjunction with CS to enable
the read and write operations.
Chip Select (Input). This active low input is used by a microprocessor to activate
the microprocessor port.
Read/Write (Input). This input controls the direction of the data bus lines (D7-D0)
during a microprocessor access.
Data Transfer Acknowledgment (Open Drain Output). This active low output
indicates that a data bus transfer is completed. A pull-up resistor (1K typical) is
required at this output.
Data Bus D0 - D7 (Bidirectional). These pins form the 8-bit bidirectional data bus
of the microprocessor port.
the internal registers.
Output Drive Enable (Input). This input pin is logically AND’d with the ODE bit-6
of the Main Control Register. When both ODE bit and ODE input pin are high, the
Rout and Sout ST-BUS outputs are enabled.
When the ODE bit is low or the ODE input pin is low, the Rout and Sout ST-BUS
outputs are high impedance.
Send PCM Signal Output (Output). Port 1 TDM data output streams.
Sout pin outputs serial TDM data streams at 2.048 Mb/s with 32 channels per
stream.
Receive PCM Signal Output (Output). Port 2 TDM data output streams. Rout pin
outputs serial TDM data streams at 2.048 Mb/s with 32 channels per stream.
Send PCM Signal Input (Input). Port 2 TDM data input streams.
Sin pin receives serial TDM data streams at 2.048 Mb/s with 32 channels per
stream.
Receive PCM Signal Input (Input). Port 1 TDM data input streams.
Rin pin receives serial TDM data streams at 2.048 Mb/s with 32 channels per
stream.
Frame Pulse (Input). This input accepts and automatically identifies frame
synchronization signals formatted according to ST-BUS or GCI interface
specifications.
Serial Clock (Input). 4.096 MHz serial clock for shifting data in/out on the serial
streams (Rin, Sin, Rout, Sout).
Description
MT9300
3