tea1753lt NXP Semiconductors, tea1753lt Datasheet - Page 12

no-image

tea1753lt

Manufacturer Part Number
tea1753lt
Description
Tea1753lt Greenchip Iii Smps Control Ic
Manufacturer
NXP Semiconductors
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
TEA1753LT
Manufacturer:
NXP
Quantity:
8 000
NXP Semiconductors
TEA1753LT
Objective data sheet
7.2.10 Mains undervoltage lockout / brownout protection (VINSENSE pin)
7.2.8 Dual boost PFC
7.2.9 Overcurrent protection (PFCSENSE pin)
The PFC output voltage is modulated by the mains input voltage. The mains input voltage
is measured via the VINSENSE pin. The current is sourced from the VOSENSE pin if the
voltage on the VINSENSE pin drops below 2.2 V. To ensure the stable switch-over, a
200 mV transition region is inserted around the 2.2 V, see
For low VINSENSE input voltages, the output current is 8 A. This output current, in
combination with the resistors on the VOSENSE pin, sets the lower PFC output voltage
level at low mains voltages. At high mains input voltages the current is switched to zero.
The PFC output voltage will then be at its maximum. As this current is zero in this
situation, it does not effect the accuracy of the PFC output voltage.
For proper switch-off behavior, the VOSENSE current is switched to its maximum value of
8 A, as soon as the voltage on pin VOSENSE drops below 2.1 V .
The maximum peak current is limited cycle-by-cycle by sensing the voltage across an
external sense resistor, R
measured via the PFCSENSE pin.
To prevent the PFC from operating at very low mains input voltages, the voltage on the
VINSENSE pin is sensed continuously. As soon as the voltage on this pin drops below the
V
Fig 6. PFC start/stop via PPFCTIMER pin
Fig 7.
stop(VINSENSE)
Voltage to current transfer function for dual boost PFC
level, switching of the PFC is stopped.
All information provided in this document is subject to legal disclaimers.
low power
I
I(VOSENSE)
Rev. 01 — 4 March 2011
SENSE1
−8 μA
, on the source of the external MOSFET. The voltage is
5 µA
14
3.75 V
1.25 V
PFCTIMER
2.2 V
R
S
V
Q
GreenChip III SMPS control IC
VINSENSE
Figure
014aaa097
low power delay
(PFC on)
TEA1753LT
7.
014aaa740
© NXP B.V. 2011. All rights reserved.
12 of 31

Related parts for tea1753lt