PN5110A0HN NXP [NXP Semiconductors], PN5110A0HN Datasheet - Page 16

• Manufacturer Part Number: PN5110A0HN
• Description: Transmission Module
• Manufacturer: NXP [NXP Semiconductors]

NXP Semiconductors
082733
Product short data sheet
8.2.3 NFCIP-1 framing and coding
8.2.4 NFCIP-1 Protocol Support
8.3 Card Operation mode
The NFCIP-1 framing and coding in Active and Passive Communication mode is defined
in the NFCIP-1 standard.
Table 11.
The NFCIP-1 protocol is not completely described in this document. For detailed
explanation of the protocol refer to the NFCIP-1 standard. However the datalink layer is
according to the following policy:
In order not to disturb current infrastructure based on 13.56 MHz general rules to start
NFCIP-1 communication are defined in the following way.
The PN511 can be addressed like a FeliCa or ISO 14443A/Mifare card. This means that
the PN511 can generate an answer in a load modulation scheme according to the
ISO 14443A/Mifare or FeliCa interface description.
Note: The PN511 does not support a complete card protocol. This has to be handled by a
dedicated card SAM or a host controller. The card-SAM is optional.
Transfer speed
106 kbit/s
212 kbit/s
424 kbit/s
1. Per default NFCIP-1 device is in Target mode meaning its RF field is switched off.
2. The RF level detector is active.
3. Only if application requires the NFCIP-1 device shall switch to Initiator mode.
4. Initiator shall only switch on its RF field if no external RF field is detected by RF Level
5. The initiator performs initialization according to the selected mode.
Fig 11. Card Operation mode
•
•
Speed shall not be changed while continuum data exchange in a transaction.
Transaction includes initialization and anticollision methods and data exchange (in
continuous way, meaning no interruption by another transaction).
detector during a time of TIDT.
Reader/ Writer for FeliCa
Generates RF
Framing and Coding Overview
or MIFARE
field
Rev. 3.3 — 13 June 2007
Framing and Coding
According to the ISO 14443A/Mifare scheme
According to the FeliCa scheme
According to the FeliCa scheme
PN511
Loadmodulation
Transmission Module
Answers in
scheme
© NXP B.V. 2007. All rights reserved.
Sam (opt.)
µC and
Battery
PN511
16 of 22