ADP5062CP-EVALZ Analog Devices, ADP5062CP-EVALZ Datasheet - Page 16

• Manufacturer Part Number: ADP5062CP-EVALZ
• Description: Power Management IC Development Tools ADP5062 Evaluation board
• Manufacturer: Analog Devices
• Type: Linear Regulators - Standardr
• Series: ADP5062r

Specifications of ADP5062CP-EVALZ

• Rohs: yes
• Product: Evaluation Boards
• Tool Is For Evaluation Of: ADP5062
• Input Voltage: 4 V to 6.7 V
• Description/function: Battery charger (isolated flyback)
• Interface Type: I2C
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Output Current: 2.1 A
• Factory Pack Quantity: 1
• For Use With: ADP5062

ADP5062
INTRODUCTION
The
cell lithium-ion or lithium-polymer batteries suitable for a wide
range of portable applications.
The linear charger architecture enables up to 2.1 A output
current at 4.3 V to 5.0 V (I
power supply, and up to 1.3 A charge current into the battery
from a dedicated charger.
The
but is tolerant of voltages of up to 20 V. The 20 V voltage tolerance
alleviates the concerns of the USB bus spiking during discon-
nection or connection scenarios.
The
output and the battery. This feature permits battery isolation
and, hence, system powering under a dead battery or no battery
scenario, which allows for immediate system function upon
connection to a USB power supply.
The
Battery Charging Specification 1.2. The
via the mini USB VBUS pin from a wall charger, car charger, or
USB host port. Based on the type of USB source, which is detected
ADP5062
ADP5062
ADP5062
ADP5062
features an internal FET between the linear charger
is a fully-programmable I
operates from an input voltage of 4 V up to 6.7 V
is fully compliant with USB 3.0 and the USB
2
C programmable) on the system
ADP5062
2
C charger for single
is chargeable
Rev. 0 | Page 16 of 44
by an external USB detection device, the
apply the correct current limit for optimal charging and USB
compliance. The USB charger permits correct operation under
all USB compliant sources such as wall chargers, host chargers,
hub chargers, and standard host and hubs.
A processor can control the USB charger using the I
program the charging current and numerous other parameters,
including
•
•
•
•
•
•
•
•
•
•
•
•
Trickle charge current level
Trickle charge voltage threshold
Weak charge (constant current) current level
Fast charge (constant current) current level
Fast charge (constant voltage) voltage level at 1% accuracy
Fast charge safety timer period
Watchdog safety timer parameters
Weak battery threshold detection
Charge complete threshold
Recharge threshold
Charge enable/disable
Battery pack temperature detection and automatic charger
shutdown
ADP5062
Data Sheet
can be set to
2
C to