STEVAL-IHM015V1 STMicroelectronics, STEVAL-IHM015V1 Datasheet - Page 33

• Manufacturer Part Number: STEVAL-IHM015V1
• Description: BOARD EVAL ST7FMC2S4T6/STS8DNH3L
• Manufacturer: STMicroelectronics
• Type: Motor / Motion Controllers & Driversr

Specifications of STEVAL-IHM015V1

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST7FMC2S4, STS8DNH3LL
• Primary Attributes: 3-Ph BLAC, BLDC, PMAC or PMDC Motors
• Secondary Attributes: Graphical User Interface
• Input Voltage: 5 V to 48 V
• Product: Power Management Modules
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: ARM7TDMI
• Silicon Core Number: ST7
• Silicon Family Name: ST7MCx
• Kit Contents: Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: ST7MC2S4, STS8DNH3LL
• Other names: 497-8213

UM0432
Note:
7.4.10
Note:
1
2
Make sure that the following string: "<firmware name>.elf - 0 error(s), 0 warning(s)" is
displayed inside the output pane after the building of the executable.
After the building of the executable, ensure that the file "<firmware name>.s19" generated
inside the "release" folder in the workspace has been created. To do this, show the
properties and check the creation date.
Programming the firmware
Before programming the firmware, the board must be supplied and connected to the PC
using the inDART board. We suggest setting up the system as depicted in
Figure 19. System setup for programming phase
1.
Windows 2000® and Windows XP® may issue a warning the first time the inDART-STX
power board is connected to the PC. The USB driver used by inDART-STX is not digitally
signed by Microsoft, however, the user may safely ignore the warning since every kind of
compatibility and security test has been carried out by Softec Microsystems.
2.
3.
4.
Once the ST7VD for inDART has been installed, the "datablaze programmer" utility that can
be used to program the firmware using the inDART-STX is automatically installed.
5.
6.
7.
Use the USB cable to connect the inDART-STX board to the PC. The green LED on the
inDART-STX board lights up. The Windows® operating system automatically detects
the new hardware and loads the appropriate USB and inDART-STX drivers.
Connect the inDART board with the J1 connector using the 10-pin flat cable.
Before supplying the board, remove J23 and J24. Check that J8 is connected between
pins 1 and 2.
Supply the control board using a 10-V power supply connected to J6 observing the
polarity.
Run the Softec datablaze programmer utility.
Click on Select Device on the toolbar.
In the Select Device window, select "inDART-STX" in the Programmer Hardware box,
and "ST7FMC2S4" as the device code, and press OK.
Motor control operations
Figure
19.
33/53