STEVAL-IHM015V1 STMicroelectronics, STEVAL-IHM015V1 Datasheet - Page 45

• Manufacturer Part Number: STEVAL-IHM015V1
• Description: BOARD EVAL ST7FMC2S4T6/STS8DNH3L
• Manufacturer: STMicroelectronics
• Type: Motor / Motion Controllers & Driversr

Specifications of STEVAL-IHM015V1

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST7FMC2S4, STS8DNH3LL
• Primary Attributes: 3-Ph BLAC, BLDC, PMAC or PMDC Motors
• Secondary Attributes: Graphical User Interface
• Input Voltage: 5 V to 48 V
• Product: Power Management Modules
• Silicon Manufacturer: ST Micro
• Core Architecture: ARM
• Core Sub-architecture: ARM7TDMI
• Silicon Core Number: ST7
• Silicon Family Name: ST7MCx
• Kit Contents: Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: ST7MC2S4, STS8DNH3LL
• Other names: 497-8213

UM0432
7.7.2
7.7.3
7.7.4
7.7.5
Specific jumper settings
Set-up the board as per the instructions in
and
Table 21.
Set-up the board as per
LED action after power-on
Turn on the power supply. For this demonstration the power supply output voltage should be
set to 30 Vdc and the current limitation of the power supply should be set to 4 A.
After power-on, the control board LEDs should blink green and red alternatingly, signaling
that the firmware has started to run. After a while a green LED stays on indicating an "idle"
state.
Setting the potentiometers
Before running the motor the two potentiometers P1 and P3 must be set (see
the correct configuration).
Running the motor (LED action)
Push the Start/Stop button. After pushing the button, the LEDs toggle from green to red to
indicate the "run" state. Turn P1 in a clockwise direction. Keeping P1 fixed, turn P3 in a
clockwise direction until the motor runs.
Section
7.4.13.
PMAC SR jumper settings
PMAC_3PH_SR
Driving mode
Table
21.
Section 7.4.12
J11 open, J12 open, J13 between 2-3
J15 open, J16 open, J17 between 2-3
J18 open, J19 open, J20 between 2-3
(bus voltage between 9 and 28 V)
Jumper settings
Motor control operations
Table 22
45/53
for