ATSAM3S1BA-AU Atmel, ATSAM3S1BA-AU Datasheet - Page 1056

• Manufacturer Part Number: ATSAM3S1BA-AU
• Description: IC MCU 32BIT 64KB FLASH 64LQFP
• Manufacturer: Atmel
• Series: SAM3Sr

Specifications of ATSAM3S1BA-AU

• Core Processor: ARM® Cortex-M3™
• Core Size: 32-Bit
• Speed: 64MHz
• Connectivity: I²C, MMC, SPI, SSC, UART/USART, USB
• Peripherals: Brown-out Detect/Reset, DMA, I²S, POR, PWM, WDT
• Number Of I /o: 47
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 1.62 V ~ 1.95 V
• Data Converters: A/D 10x10/12b, D/A 2x12b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-LQFP
• Controller Family/series: ATSAM3S
• No. Of I/o's: 47
• Ram Memory Size: 16KB
• Cpu Speed: 64MHz
• No. Of Timers: 6
• Rohs Compliant: Yes
• Processor Series: ATSAM3x
• Core: ARM Cortex M3
• 3rd Party Development Tools: JTRACE-CM3, MDK-ARM, RL-ARM, ULINK2
• Development Tools By Supplier: ATSAM3S-EK
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details

41.4.9
41.4.9.1
41.4.9.2
1056
SAM3S Preliminary
Crystal Oscillators Design Consideration Information
Choosing a Crystal
Printed Circuit Board (PCB)
When choosing a crystal for the 32768 Hz Slow Clock Oscillator or for the 3-20 MHz Oscillator,
several parameters must be taken into account. Important parameters between crystal and
SAM3S specifications are as follows:
SAM3S Oscillators are low power oscillators requiring particular attention when designing PCB
systems.
• Load Capacitance
• Drive Level
• Equivalent Series Resistor (ESR)
• Shunt Capacitance
– C
– Crystal drive level >= Oscillator Drive Level. Having a crystal drive level number
– Crystal ESR <= Oscillator ESR Max. Having a crystal with ESR value higher than
– Max. crystal Shunt capacitance <= Oscillator Shunt Capacitance (
order to oscillate at the target frequency. The crystal must be chosen according to
the internal load capacitance (C
load capacitance will result in a frequency drift.
lower than the oscillator specification may damage the crystal.
the oscillator may cause the oscillator to not start.
crystal with ESR value higher than the oscillator may cause the oscillator to not start.
crystal
is the equivalent capacitor value the oscillator must “show” to the crystal in
L
) of the on-chip oscillator. Having a mismatch for the
C
SHUNT
6500C–ATARM–8-Feb-11
).
Having a