SAK-XC888CLM-8FFA 5V AC Infineon Technologies, SAK-XC888CLM-8FFA 5V AC Datasheet - Page 97

• Manufacturer Part Number: SAK-XC888CLM-8FFA 5V AC
• Description: IC MCU 8BIT FLASH 64-LQFP
• Manufacturer: Infineon Technologies
• Series: XC8xxr

Specifications of SAK-XC888CLM-8FFA 5V AC

• Core Processor: XC800
• Core Size: 8-Bit
• Speed: 103.2MHz
• Connectivity: CAN, LIN, SSI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 48
• Program Memory Size: 32KB (32K x 8)
• Program Memory Type: FLASH
• Ram Size: 1.75K x 8
• Voltage - Supply (vcc/vdd): 4.5 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 125°C
• Package / Case: 64-LFQFP
• Data Bus Width: 8 bit
• Data Ram Size: 1.75 KB
• Interface Type: UART, SSC
• Maximum Clock Frequency: 24 MHz
• Number Of Programmable I/os: 48
• Number Of Timers: 4
• Operating Supply Voltage: 5 V
• Maximum Operating Temperature: + 125 C
• Mounting Style: SMD/SMT
• Minimum Operating Temperature: - 40 C
• On-chip Adc: 10 bit, 8 Channel
• For Use With: B158-H8743-X-X-7600IN - KIT STARTER XC886/888
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Lead Free Status / Rohs Status: Details
• Other names: SP000210982

XC886/888CLM
Functional Description
needed for the handshaking between the master and slave tasks is provided by the
master task through the header portion of the frame.
The header consists of a break and synch pattern followed by an identifier. Among these
three fields, only the break pattern cannot be transmitted as a normal 8-bit UART data.
The break must contain a dominant value of 13 bits or more to ensure proper
synchronization of slave nodes.
In the LIN communication, a slave task is required to be synchronized at the beginning
of the protected identifier field of frame. For this purpose, every frame starts with a
sequence consisting of a break field followed by a synch byte field. This sequence is
unique and provides enough information for any slave task to detect the beginning of a
new frame and be synchronized at the start of the identifier field.
Upon entering LIN communication, a connection is established and the transfer speed
(baud rate) of the serial communication partner (host) is automatically synchronized in
the following steps:
STEP 1: Initialize interface for reception and timer for baud rate measurement
STEP 2: Wait for an incoming LIN frame from host
STEP 3: Synchronize the baud rate to the host
STEP 4: Enter for Master Request Frame or for Slave Response Frame
Note: Re-synchronization and setup of baud rate are always done for every Master
Request Header or Slave Response Header LIN frame.
Data Sheet
90
V1.2, 2009-07