ATMEGA8535L-8AC Atmel, ATMEGA8535L-8AC Datasheet - Page 253

• Manufacturer Part Number: ATMEGA8535L-8AC
• Description: IC AVR MCU 8K LV 8MHZ COM 44TQFP
• Manufacturer: Atmel
• Series: AVR® ATmegar

Specifications of ATMEGA8535L-8AC

• Core Processor: AVR
• Core Size: 8-Bit
• Speed: 8MHz
• Connectivity: I²C, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 32
• Program Memory Size: 8KB (4K x 16)
• Program Memory Type: FLASH
• Eeprom Size: 512 x 8
• Ram Size: 512 x 8
• Voltage - Supply (vcc/vdd): 2.7 V ~ 5.5 V
• Data Converters: A/D 8x10b
• Oscillator Type: Internal
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 44-TQFP, 44-VQFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Data Polling EEPROM
2502K–AVR–10/06
When a new byte has been written and is being programmed into EEPROM, reading the
address location being programmed will give the value 0xFF. At the time the device is
ready for a new byte, the programmed value will read correctly. This is used to deter-
mine when the next byte can be written. This will not work for the value 0xFF, but the
user should have the following in mind: As a chip erased device contains 0xFF in all
locations, programming of addresses that are meant to contain 0xFF, can be skipped.
This does not apply if the EEPROM is reprogrammed without chip erasing the device. In
this case, data polling cannot be used for the value 0xFF, and the user will have to wait
at least t
value.
Table 108. Minimum Wait Delay Before Writing the Next Flash or EEPROM Location
Figure 125. Serial Programming Waveforms
Symbol
t
t
t
t
SERIAL DATA OUTPUT
WD_FLASH
WD_EEPROM
WD_ERASE
WD_FUSE
SERIAL CLOCK INPUT
SERIAL DATA INPUT
WD_EEPROM
SAMPLE
(MOSI)
(MISO)
(SCK)
before programming the next byte. See Table 108 for t
MSB
MSB
Minimum Wait Delay
4.5 ms
9.0 ms
9.0 ms
4.5 ms
ATmega8535(L)
LSB
LSB
WD_EEPROM
253