DK-DEV-4SGX530N Altera, DK-DEV-4SGX530N Datasheet - Page 33

• Manufacturer Part Number: DK-DEV-4SGX530N
• Description: KIT DEVELOPMENT STRATIX IV
• Manufacturer: Altera
• Series: Stratix® IV GXr
• Type: FPGAr

Specifications of DK-DEV-4SGX530N

• Contents: Board, Cable, Documentation, Power Supply
• For Use With/related Products: Stratix® IV GX
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 544-2714

Chapter 2: Board Components
General User Input/Output
Table 2–21. Stratix IV GX FPGA Development Board Clock Outputs (Part 2 of 2)
Table 2–22. Crystal Oscillator Component References and Manufacturing Information
General User Input/Output
August 2010 Altera Corporation
Samtec HSMC
Samtec HSMC
X1
X2
X3
X6
X7
X8
X9
Note for
(1) The crystal oscillator whose component reference and manufacturing information on the engineering silicon board differ from the production
Reference
Connector
Board
silicon board is listed in
Table
User-Defined Push-Button Switches
2–22:
125 MHz LVDS Saw Oscillator
156.25 MHz LVDS Saw
Oscillator
148.5 MHz Voltage Controlled
LVDS Crystal Oscillator
100 MHz LVDS Programmable
Crystal Oscillator
155.5 MHz LVPECL Saw
Oscillator
50 MHz Crystal Oscillator
125 MHz Crystal Oscillator
Schematic Signal Name
HSMB_CLK_OUT_P1
HSMB_CLK_OUT_N1
HSMB_CLK_OUT_P2
HSMB_CLK_OUT_N3
Table 2–22
information.
This section describes the user I/O interface to the FPGA, including the push-buttons,
DIP switches, status LEDs, and character LCD.
The development board includes four user-defined push-button switches: three
general switches and one CPU reset. For information on the system and safe reset
push-button switches, refer to
page
Board references S3, S4, and S5 are push-button switches that allow you to interact
with the Stratix IV GX device. When the switch is pressed and held down, the device
pin is set to logic 0; when the switch is released, the device pin is set to logic 1. There is
no board-specific function for these general user push-button switches.
Description
Table A–3 on page
2–19.
lists the crystal oscillators component references and manufacturing
A–3.
K10
J10
Pin
K8
J8
Epson
Epson
Connor-Winfield
Silicon Labs
Epson
Epson
ECS
Manufacturer
LVDS or 2.5-V
LVDS or 2.5-V
I/O Standard
“Reset Configuration Push-Button Switch” on
EG-2121CA
125.0000M-LGPNL3
EG-2121CA
156.2500M-LHPNL3
V902-148.5MHz
570FAB000433DG
EG-2121CA
155.5200M-PGPNL3
XG-1000CB
50.0000M-DCL3
ECS-3525-1250-B
Manufacturer
Stratix IV GX FPGA Development Board Reference Manual
Part Number
LVDS output. Can also support two CMOS
LVDS output or two 2.5-V CMOS outputs.
(Note 1)
Description
outputs.
www.eea.epson.com
www.eea.epson.com
www.conwin.com
www.silabs.com
www.eea.epson.com
www.eea.epson.com
www.ecsxtal.com
Manufacturer Website
2–25