RN-134-K Roving Networks Inc, RN-134-K Datasheet - Page 12

• Manufacturer Part Number: RN-134-K
• Description: KIT EVAL WIFLY GSX 802.11 RN-134
• Manufacturer: Roving Networks Inc
• Type: Transceiver, 802.11 b/gr

Specifications of RN-134-K

• Frequency: 2.4GHz
• Wireless Frequency: 2402 MHz to 2480 MHz
• Interface Type: RS-232, UART
• Modulation: CKK, DSSS, DBPSK, DQPSK, OFDM
• Security: 128 WEP, WPA, TKIP
• Operating Voltage: 3 V to 12 V
• Operating Temperature Range: - 40 C to + 85 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: RN-134
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1035

set broadcast interval <value> sets the interval at which the hello/heartbeat UDP message is sent.
set broadcast port <port>
set comm $ <char>
set comm close <string>
set comm open <string>
set comm remote <string>
set comm idle <secs>
set comm match <value>
set comm size <value>
5.3. COMM Parameters
www.rovingnetworks.com
809 University Avenue
•
Los Gatos, CA 95032
Interval is specified in seconds. The value is a mask that is compared to a
free running seconds counter. For example if interval = 0x7, a packet will
be sent every 8 seconds. The minimum interval value is 1 (every 2
seconds) and max value is 0xff (every 256 seconds). Setting the interval
value to zero disables sending UDP broadcast messages. The default
interval is 7.
sets the port number to which the UDP hello/heartbeat message is sent.
The default port is 55555.
sets character used to enter command mode. Typically used when “$$$” is
a possible data string. Default is ‘$’. Care should be taken when setting
this to note the new character as once this setting is saved every
subsequent reboot will ignore “$$$” and look for “<char><char><char>”.
sets the ASCI string that is sent to the local UART when the TCP port is
closed. If no string is desired, use 0 as the <string> parameter. Max string
length is 32 characters. Default is *CLOS*
sets the string that is sent to the local UART when the TCP port is opened.
If no string is desired, use 0 as the <string> parameter. Max string length
is 32 characters. Default is *OPEN*
sets the string that is sent to the remote TCP client when the TCP port is
opened. If no string is desired, use 0 as the <string> parameter. Max string
length is 32 characters. Default is *HELLO*
sets the Idle Timer Value. This is the number of seconds with no transmit
or receive data before the connection is closed automatically. Default is 0,
never disconnect on idle.
sets match character. An IP packet will be sent each time the match
character appears in the data. Value is entered as the decimal (13) or hex
(0xd) of the of the ASCII character. Default is 0, disabled. The match
character is one of three ways to control TCP/IP packet forwarding. The
others are size and timer. For more information see section 10.1 on
System Timers and Auto Connect Timers and section 10.4 on UART
Receiver.
sets the flush size. An IP packet will be sent each time “value” bytes are
received. Default is 64 bytes. You should set this value to the largest
~ 12 ~
•
Tel [phone]
• [e-mail]
WiFlyGSX-um
WiFly GSX
9/16/2010