RN-134-K Roving Networks Inc, RN-134-K Datasheet - Page 65

• Manufacturer Part Number: RN-134-K
• Description: KIT EVAL WIFLY GSX 802.11 RN-134
• Manufacturer: Roving Networks Inc
• Type: Transceiver, 802.11 b/gr

Specifications of RN-134-K

• Frequency: 2.4GHz
• Wireless Frequency: 2402 MHz to 2480 MHz
• Interface Type: RS-232, UART
• Modulation: CKK, DSSS, DBPSK, DQPSK, OFDM
• Security: 128 WEP, WPA, TKIP
• Operating Voltage: 3 V to 12 V
• Operating Temperature Range: - 40 C to + 85 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: RN-134
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1035

As of Version 2.12 9/17/2009
As of Version 2.11 9/8/2009 – Limited release (please update to 2.12)
As of Version 2.10 8/14/2009
• Fixed problem with some newer 802.11n - association attempts cause module to crash/reboot. (Such
• Fixed problem with send on match character i.e. set comm match char. Match char is now
• During an open TCP session, a second incoming connection would be accepted. Second connection
• Hardware flow control is now supported. To enable, use the “set uart flow 1” command.
• DHCP renew and rebind is fully supported. Previously, DHCP renew/rebind would update IP
Features
• TCP connection password. This optional pass word is enabled with the command “set opt pass
• UART instant baudrate The set uart instant <rate> command immediately changes the baudrate.
• Analog interface commands The “show q” command will now enable and show the digital value of
• Added a 250ms guard band in parsing of $$$. The module now looks for three $$$, and only three
• Fixed problem with UART dropping data. In cases with large data transfers (>100KB) the UART
• We no longer pass serial data received into the UART back over telnet when in remote command
Features
www.rovingnetworks.com
commands to the module. NOTE: For consistency, the command prompt response <2.xx> now
also contains \r\n appended string when in this mode.
as Linksys WRT160NL)
operational.
is now accepted but then immediately closed.
settings, and if a TCP session was active it would enter a hung state. TCP connections now survive
a DHCP renew/rebind.
<string>”, incoming connections will be challenged and the stored password must be matched or the
connection will be closed.
This is useful when testing baudrate settings, or switching baudrate “on the fly” remotely while
connected over TCP.
the analog interface pins. See section 16
$$$ within a 250ms period with no additional characters following for 250 ms. Do not send \cr or
\lf after the $$$.
would become over whelmed and drop data.
mode
809 University Avenue
•
Los Gatos, CA 95032
~ 65 ~
•
Tel [phone]
• [e-mail]
WiFlyGSX-um
WiFly GSX
9/16/2010