RN-134-K Roving Networks Inc, RN-134-K Datasheet - Page 17

• Manufacturer Part Number: RN-134-K
• Description: KIT EVAL WIFLY GSX 802.11 RN-134
• Manufacturer: Roving Networks Inc
• Type: Transceiver, 802.11 b/gr

Specifications of RN-134-K

• Frequency: 2.4GHz
• Wireless Frequency: 2402 MHz to 2480 MHz
• Interface Type: RS-232, UART
• Modulation: CKK, DSSS, DBPSK, DQPSK, OFDM
• Security: 128 WEP, WPA, TKIP
• Operating Voltage: 3 V to 12 V
• Operating Temperature Range: - 40 C to + 85 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: RN-134
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1035

set sys autoconn <secs>
set sys autosleep <num>
set sys iofunc <value>
set sys mask <mask>
set sys printlvl <value>
set sys output <value> <mask> sets output PIO pins to HIGH or LOW. Bit-mapped value. Optional
set sys sleep <secs>
set sys trigger <value>
set sys wake <secs>
set time address <addr>
5.8. System Parameters
5.9. Time Server Parameters
www.rovingnetworks.com
809 University Avenue
Sets the auto-sleep timer. 0 disables. If the protocol is set to UDP ONLY, this
<num> ms after transmission of the first UDP packet.
•
Los Gatos, CA 95032
TCP mode: sets the auto connect timer. This command causes the module
periodically connect to the host. The timer <secs> determines how often
to connect to the stored remote host. If set to 1, the module will only
make one attempt to auto connect upon power up. If set to 2 or greater
auto connect will re-open the connection after the connection is closed.
Default=0 disables.
timer is used as a quick sleep function. Device will sleep
sets the IO port alternate functions. Bit-mapped value. For more details
see section 10.5
sets the IO port direction mask. Bit-mapped value. For more information
see section 10.5
sets numerous print functions. 0 = quiet, 1 = connect information Default
is 1 . Please refer section 10.6 on Setting Debug Print levels
mask only sets a subset of pins.
sets the sleep timer. 0 disables.
NOTE: If not using Sensor pins to wake the module, be sure to set the
wake timer before issuing the sleep timer or the module will not wake up.
See section 10.1 for more details on using system timers
sets the sensor input(s) to wake on (0-3). Bit-mapped value. 0 disables.
sets the auto wake timer. 0 disables. See section 10.1 for more details on
using system timers
sets the time server address. (sNTP servers)
~ 17 ~
•
Tel [phone]
• [e-mail]
WiFlyGSX-um
WiFly GSX
9/16/2010