RN-134-K Roving Networks Inc, RN-134-K Datasheet - Page 19

• Manufacturer Part Number: RN-134-K
• Description: KIT EVAL WIFLY GSX 802.11 RN-134
• Manufacturer: Roving Networks Inc
• Type: Transceiver, 802.11 b/gr

Specifications of RN-134-K

• Frequency: 2.4GHz
• Wireless Frequency: 2402 MHz to 2480 MHz
• Interface Type: RS-232, UART
• Modulation: CKK, DSSS, DBPSK, DQPSK, OFDM
• Security: 128 WEP, WPA, TKIP
• Operating Voltage: 3 V to 12 V
• Operating Temperature Range: - 40 C to + 85 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: RN-134
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 740-1035

If this setting is enabled (set uart mode 0x10), any unsent RX data is still in the buffer is flushed when a
connection is closed.
set uart tx <0, 1>
NOTE: Due to an issue in the UART hardware, the UART does not support even or odd parity.
set wlan auth <value>
set wlan channel <value>
set wlan ext_antenna <0, 1>
5.11. WLAN Parameters
www.rovingnetworks.com
1) more chars come in, in which case it will get flushed, or
2) no chars come in and a new connection is made, then the chars will get forwarded.
809 University Avenue
•
Los Gatos, CA 95032
Disables or enables the TX pin= PIO10 of the UART. Disable will set
PIO10 to an INPUT with weak pulldown.
Sets the authentication mode. Not needed unless using auto join mode 2.
i.e. set wlan join 2
Note: During association the WiFly module interrogates the Access Point
and automatically selects the authentication mode.
The current release of Wifly firmware supports these security modes:
• WEP-128 (open mode only, NOT shared mode)
• WPA2-PSK (AES only)
• WPA1-PSK (TKIP only)
• WPA-PSK mixed mode (some APs, not all are supported)
sets the wlan channel, 1-13 is the valid range for a fixed channel. If 0 is
set, then scan is performed, using the ssid, for all the channels set in the
channel mask.
determines which antenna is active, use 0 for chip antenna, 1 for UF.L
connector. Default = 0. Only one antenna is active at a time and the
module must be power cycled after switching the antenna.
Value
0
1
2
3
4
5
6
Authentication Mode
Open (Default)
WEP-128
WPA1
Mixed WPA1 & WPA2-PSK
WPA2-PSK
Not Used
Adhoc, Join any Adhoc network
~ 19 ~
•
Tel [phone]
• [e-mail]
WiFlyGSX-um
WiFly GSX
9/16/2010