EM260-RTR Ember, EM260-RTR Datasheet - Page 72

• Manufacturer Part Number: EM260-RTR
• Description: IC ZIGBEE SYSTEM-ON-CHIP 40-QFN
• Manufacturer: Ember

Specifications of EM260-RTR

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4
• Applications: ZigBee™
• Power - Output: -32dBm ~ 3dBm
• Sensitivity: -97dBm
• Voltage - Supply: 2.1 V ~ 3.6 V
• Current - Receiving: 30mA
• Current - Transmitting: 34mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: PCB, Surface Mount
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 40-QFN
• For Use With: 636-1009 - PROGRAMMER USB FLASH EM250/260
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Other names: 636-1007-2; EM260-RTR

EM260
72
120-1003-000D
Name: remoteDeleteBindingHandler
Description: The EM260 used the external binding modification policy to decide how to handle a remote
delete binding request. The Host cannot change the current decision, but it can change the policy for future
decisions using the
This frame is a response to the
Response Parameters:
int8u index
EmberStatus policyDecision
6.3.8
Name: maximumPayloadLength
Command Parameters: None
Response Parameters:
int8u apsLength
int8u transportLength
Name: sendUnicast
Description: Sends a unicast message as per the ZigBee specification. The message will arrive at its destina-
tion only if there is a known route to the destination node. Setting the ENABLE_ROUTE_DISCOVERY option will
cause a route to be discovered if none is known. Setting the FORCE_ROUTE_DISCOVERY option will force route
discovery. Routes to end-device children of the local node are always known. Setting the APS_RETRY option
will cause the message to be retransmitted until either a matching acknowledgement is received or three
transmissions have been made. The ZigBee APS retry mechanism does not use sequence numbers. If multiple
messages are sent to the same destination at the same time any acknowledgement from that node will stop
transmission of all outstanding messages. Note: Using the FORCE_ROUTE_DISCOVERY option will cause the first
transmission to be consumed by a route request as part of discovery, so the application payload of this packet
will not reach its destination on the first attempt. If you want the packet to reach its destination, the
APS_RETRY option must be set so that another attempt is made to transmit the message with its application
payload after the route has been constructed.
Command Parameters:
EmberNodeId destination
EmberApsFrame apsFrame
int8u messageTag
int8u messageLength
int8u[] messageContents
Response Parameters:
EmberStatus status
Messaging Frames
setPolicy
command.
callback
command.
The node ID to which the message will be sent.
A value chosen by the Host. This value is used in the
The unicast message.
ID: 0x32
The index of the binding whose deletion was requested.
EMBER_SUCCESS if the binding was removed from the table and
any other status if not.
ID: 0x33
The maximum APS payload length.
The maximum transport payload length.
ID: 0x34
The APS frame for the message.
castSent
The length of the
An EmberStatus value indicating success or the reason for fail-
ure.
response to refer to this message.
messageContents
parameter in bytes.
emberUni-