IS42S32800B-7TL INTEGRATED SILICON SOLUTION (ISSI), IS42S32800B-7TL Datasheet - Page 8

• Manufacturer Part Number: IS42S32800B-7TL
• Description: IC, SDRAM, 256MBIT, 143MHZ, TSOP-86
• Manufacturer: INTEGRATED SILICON SOLUTION (ISSI)

Specifications of IS42S32800B-7TL

• Memory Type: DRAM - Sychronous
• Access Time: 7ns
• Page Size: 256Mbit
• Memory Case Style: TSOP
• No. Of Pins: 86
• Operating Temperature Range: -40°C To +85°C
• Frequency: 143MHz
• Termination Type: SMD
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

IS42S32800B
8
3
4
PrechargeAll command
(RAS#=”L”,CAS#=”H”,WE#=”L”,BS =Don t care,A10 =”H”)
The Precharge All command precharges all the four banks simultaneously and can be issued even if all banks are
not in the active state. All banks are then switched to the idle state.
Read command
(RAS#=”H”,CAS#=”L”,WE#=”H”,BS =Bank,A10 =”L”,A0-A8 =Column Address)
The Read command is used to read a burst of data on consecutive clock cycles from an active row in an active
bank.The bank must be active for at least tRCD(min.) before the Read command is issued.During read bursts,
the valid data-out element from the starting column address will be available following the CAS# latency after the
issue of the Read command.Each subsequent data- out element will be valid by the next positive clock edge (refer
to the following figure).The DQs go into high-impedance at the end of the burst unless other command is initiated.
The burst length,burst sequence,and CAS# latency are determined by the mode register which is already
programmed.A full-page burst will continue until terminated (at the end of the page it will wrap to column 0 and
continue).
Integrated Silicon Solution, Inc.
07/21/09
Rev. F