LSM303DLHTR STMicroelectronics, LSM303DLHTR Datasheet - Page 17

• Manufacturer Part Number: LSM303DLHTR
• Description: IC ACCELEROMETER 3AXIS 3D 28LGA
• Manufacturer: STMicroelectronics

Specifications of LSM303DLHTR

• Output Type: Digital - I²C
• Sensor Type: Accelerometer and Magnetometer
• Sensing Axis: Triple
• Acceleration: 2 g, 4 g, 8 g
• Sensitivity: 1 mg/digit, 2 mg/digit, 3.9 mg/digit
• Package / Case: LGA-28L
• Digital Output - Number Of Bits: 16 bit
• Supply Voltage (max): 3.3 V
• Supply Voltage (min): 2.5 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 30 C
• Digital Output - Bus Interface: I2C
• For Use With: 497-10689 - BOARD ADAPTER LSM303DLH DIL24
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-10765-2; LSM303DLHTR

LSM303DLH
4
4.1
4.2
4.3
Terminology
Linear acceleration sensitivity
Linear acceleration sensitivity describes the gain of the accelerometer sensor and can be
determined e.g. by applying 1 g acceleration to it. Because the sensor can measure DC
accelerations, this can be done easily by pointing the selected axis towards the ground,
noting the output value, rotating the sensor 180 degrees (pointing towards the sky) and
noting the output value again. By doing so, a ±1 g acceleration is applied to the sensor.
Subtracting the larger output value from the smaller one, and dividing the result by 2, leads
to the actual sensitivity of the sensor. This value changes very little over temperature and
over time. The sensitivity tolerance describes the range of sensitivities of a large number of
sensors.
Zero-g level
Zero-g level Offset (LA_TyOff) describes the deviation of an actual output signal from the
ideal output signal if no linear acceleration is present. A sensor in a steady state on a
horizontal surface will measure 0 g on both the X and Y axes, whereas the Z axis will
measure 1 g. Ideally, the output is in the middle of the dynamic range of the sensor (content
of OUT registers 00h, data expressed as 2’s complement number). A deviation from the
ideal value in this case is called Zero-g offset. Offset is to some extent a result of stress to
the MEMS sensor and therefore the offset can slightly change after mounting the sensor
onto a printed circuit board or exposing it to extensive mechanical stress. Offset changes
little over temperature; see “Linear acceleration zero-g level change vs temperature”
(LA_TCOff) in
of the range of Zero-g levels of a group of sensors.
Sleep-to-wakeup
The “sleep-to-wakeup” function, in conjunction with low-power mode, allows further
reduction of system power consumption and the development of new smart applications.
The LSM303DLH may be set to a low-power operating mode, characterized by lower date
rate refreshing. In this way the device, even if sleeping, continues sensing acceleration and
generating interrupt requests.
When the sleep-to-wakeup function is activated, the LSM303DLH is able to automatically
wake up as soon as the interrupt event has been detected, increasing the output data rate
and bandwidth. With this feature the system may be efficiently switched from low-power
mode to full-performance depending on user-selectable positioning and acceleration events,
thus ensuring power-saving and flexibility.
Table 3.
The Zero-g level tolerance (TyOff) describes the standard deviation
Doc ID 16941 Rev 1
Terminology
17/47