N6761A AGILENT TECHNOLOGIES, N6761A Datasheet - Page 13
![POWER SUPPLY, BENCH, 50V, 50W](/photos/21/58/215861/4091023_sml.jpg)
N6761A
Manufacturer Part Number
N6761A
Description
POWER SUPPLY, BENCH, 50V, 50W
Manufacturer
AGILENT TECHNOLOGIES
Datasheet
1.N6751A.pdf
(20 pages)
Specifications of N6761A
Power Supply Output Type
Variable
No. Of Outputs
1
Output Voltage
50V
Output Current
1.5A
Power Rating
50W
Input Voltage
100V AC To 240 V AC
Length
596.9mm
Width
432.5mm
Height
44.45mm
Lead Free Status / RoHS Status
na
6625A, 6626A, 6628A, 6629A:
These models have 11 internal
registers, which have the
following characteristics:
• Register 0 is recalled
• Register 0 stores: VSET,
• Registers 1-10 save: VSET,
• At power-on, registers 4-10
• Registers 0-3 can only be
• If registers 0-3 are written
• When a register is recalled,
N6700A/B Mainframe:
The N6700A has 11 internal
registers, which have the fol-
lowing characteristics:
• Register 0 is recalled
automatically at power-on.
VRSET, ISET, IRSET, OVSET,
OCP, DLY, and MASK for
all outputs.
VRSET, ISET, IRSET, and
OVSET for all outputs.
are reset to 0 V and minimum
current.
saved once per power-on.
Power needs to be cycled to
re-enable writing to these
non-volatile registers.
to more than once per
power-on cycle, Error 30
“STORE LIMIT” will result.
the outputs are set
sequentially (1,2,3,4).
automatically at power-on
ONLY if the power-on state
is set to RCL0 by sending
the command “OUTPut:
PON:STATe RCL0”.
6621A, 6622A, 6623A, 6624A, 6627A
6625A, 6626A, 6628A, 6629A
N6700A/B
Table 7. Memory STO/RCL States
• All registers (0-10) store:
• At power-on registers 2-10
• The non-volatile registers
• When a register is recalled,
Table 7
ences between the 662xA and
the N6700A/B mainframes
memory states.
VSET, VRSET, ISET, IRSET,
OVSET, OCP, and DLY. The
state of the MASK register
is not stored.
are reset to minimum voltage
and minimum current.
(0-1) can be written to more
than once per power-on cycle.
the outputs are set
sequentially (1,2,3,4).
below shows the differ-
13
Non-Volatile Registers
0
4—Registers 0-3
2—Registers 0-1
Clear Command (CLR)
The Clear “CLR” command is
typically used in systems to
send all devices in the system
to a known state with a single
command. Please see
in the Initial Conditions
section for the “CLR” values.
Volatile Registers
10—Registers 1-10
7—Registers 4-10
9—Registers 2-10
Table 4