AC164139 Microchip Technology, AC164139 Datasheet - Page 89

• Manufacturer Part Number: AC164139
• Description: Graphics Display Prototype Board Graphics
• Manufacturer: Microchip Technology

Specifications of AC164139

• Main Purpose: LCD Development
• Embedded: No
• Utilized Ic / Part: PICtail™ Plus Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Secondary Attributes: -
• Primary Attributes: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

REGISTER 6-1:
TABLE 6-1:
 2010 Microchip Technology Inc.
bit 2
bit 1
bit 0
Note 1:
TRAPR (RCON<15>)
IOPUWR (RCON<14>)
CM (RCON<9>)
EXTR (RCON<7>)
SWR (RCON<6>)
WDTO (RCON<4>)
SLEEP (RCON<3>)
IDLE (RCON<2>)
BOR (RCON<1>)
POR (RCON<0>)
Note:
2:
3:
Flag Bit
All of the Reset status bits may be set or cleared in software. Setting one of these bits in software does not
cause a device Reset.
If the FWDTEN Configuration bit is ‘1’ (unprogrammed), the WDT is always enabled, regardless of the
SWDTEN bit setting.
Re-enabling the regulator after it enters Standby mode will add a delay, T
Sleep. Applications that do not use the voltage regulator should set this bit to prevent this delay from
occurring.
All Reset flag bits may be set or cleared by the user software.
IDLE: Wake-up From Idle Flag bit
1 = Device has been in Idle mode
0 = Device has not been in Idle mode
BOR: Brown-out Reset Flag bit
1 = A Brown-out Reset has occurred
Note that BOR is also set after a Power-on Reset.
0 = A Brown-out Reset has not occurred
POR: Power-on Reset Flag bit
1 = A Power-on Reset has occurred
0 = A Power-on Reset has not occurred
RESET FLAG BIT OPERATION
RCON: RESET CONTROL REGISTER
Trap Conflict Event
Illegal Opcode or Uninitialized W Register Access
Configuration Mismatch Reset
MCLR Reset
RESET Instruction
WDT Time-out
PWRSAV #0 Instruction
PWRSAV #1 Instruction
POR, BOR
POR
PIC24FJ256DA210 FAMILY
Setting Event
(1)
(CONTINUED)
VREG
, when waking up from
CLRWDT, PWRSAV
Instruction, POR
Clearing Event
POR
POR
POR
POR
POR
POR
POR
DS39969B-page 89
—
—