TLE7188F Infineon Technologies, TLE7188F Datasheet - Page 10

• Manufacturer Part Number: TLE7188F
• Description: IC DRIVER 3PH BRIDGE 48-VQFN
• Manufacturer: Infineon Technologies
• Type: High Side/Low Sider

Specifications of TLE7188F

• Applications: DC Motor Driver, 3 Phase
• Number Of Outputs: 1
• Voltage - Supply: 5.5 V ~ 28 V
• Operating Temperature: -40°C ~ 150°C
• Mounting Type: Surface Mount
• Package / Case: 48-VFQFN Exposed Pad
• Product: H-Bridge Drivers
• Rise Time: 400 ns
• Fall Time: 230 ns
• Supply Voltage (min): 5.5 V
• Supply Current: 110 mA
• Maximum Operating Temperature: + 150 C
• Mounting Style: SMD/SMT
• Bridge Type: Half Bridge
• Minimum Operating Temperature: - 40 C
• Number Of Drivers: 6
• Packages: PG-VQFN-48
• Operating Range: 5.5 - 28.0 V
• Iq: 30 ?A
• Turn On/off Current: 1.5/ 1.5 A
• D.c.-range @ 20khz: 0...100%
• Numbers Of Integrated Opamps For Load Current Measurement: 3.0
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Output: -
• Voltage - Load: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: SP000105749

2) For proper start up minimum Vs=6.5V is required
3) Duty cycle is referred to the high side input command (IHx); The duty cycles can be driven continuously and fully operational
4) total current consumption from power net (Vs and VDH)
Note: Within the functional range the IC operates as described in the circuit description. The electrical
Note: If the voltage difference between CB2 and SHx is smaller than 2V during normal operation, there is a risk
4.3
Table 1
Characteristic
Default state of ILx (if ILx left open)
Default state of IHx (if IHx left open)
Default state of ENA (if ENA left open)
Default state of INH (if INH left open)
Default State of sense amplifier output V
(ISPx=ISNx=0V)
Status of the device and the outputs when
ENA=INH='1'
Pull up or pull down integrated resistors
Ixx, ENA
Pull down integrated resistor INH
Note: The load condition “C=22nF; R
Data Sheet
characteristics are specified within the conditions given in the related electrical characteristics table.
that the high side output can switch on and off without a corresponding input signal. As soon as this supply
voltage recovers and the input signal changes, the output stage is automatically aligned to the input again.
R
to GND and the corresponding Sxx. The voltage is measured at the positive terminal of the C
Load
is connected between the output Gxx and the positive terminal of the C. The negative terminal of the C is connected
Default State of Inputs
Default State of Inputs
Load
=1
Ω
OX
” in the paragraph “Electrical characteristics / Dynamic characteristic” means that
State
Low
High
Low
Low
Zero ampere equivalent
Device active and outputs functional
30k
45k
Ω
Ω
+/-40%
+/-40%
10
General Product Characteristics
Remark
Low side MOSFETs off
High side MOSFETs off
Device/outputs disabled
Sleep mode,
–
V
–
–
s
=5.5 ... 28V
V2.1, 2007-06-20
TLE7188F
I
Q
< 30 µA