750-841 WAGO, 750-841 Datasheet - Page 77

• Manufacturer Part Number: 750-841
• Description: CONTR.ETHERNET TCP/IP 10/100MBIT
• Manufacturer: WAGO

Specifications of 750-841

• Rohs Compliant: YES
• No. Of Digital Inputs: 10
• No. Of Digital Outputs: 10

3.1.7.2 Variation 2:Starting up with the WAGO BootP Server
3.1.7.2.1 Note the MAC-ID and establish the Fieldbus Node
3.1.7.2.2 Connecting PC and Fieldbus Node
WAGO-I/O-SYSTEM 750
ETHERNET TCP/IP
1. Noting the MAC-ID and establishing the fieldbus node
2. Connecting the PC and fieldbus node
3. Determining the IP address
4. Allocation of the IP address to the fieldbus node
5. Function of the fieldbus tests
6. Deactivating the BootP Protocol
This procedure contains the following steps:
4. When the test has been performed successfully, you can close the DOS
5. Since the IP address is still temporarily stored in the controller. Do not
Attention
For a direct connection to a PC, a “crossover” cable is required instead of a
parallel cable.
Before establishing your fieldbus node, please note the hardware address
(MAC-ID) of your ETHERNET fieldbus controller.
This is located on the rear of the fieldbus controller and on a self-adhesive
tear-off label on the side of the fieldbus controller.
MAC-ID of the fieldbus controller:
Connect the assembled ETHERNET TCP/IP fieldbus node to a hub using a
standard Ethernet cable, or directly to the PC with a “crossover” cable. The
transmission rate of the controller is dependant on the baud rate of the PC
network interface card.
Now start the BootP server on the PC and apply power to the controller (DC
24 V power pack). Once the operating voltage has been switched on, the PFC
initialization starts. The fieldbus controller determines the configuration of the
Note
When starting up the 750-841 controller, there are a number of important
factors to consider, since the start-up of this controller differs significantly in
certain respects from the 750-842 ETHERNET controller.
prompt.
cycle power on the controller until the BootP protocol has been disabled in
the PFC.
----- ----- ----- ----- ----- -----.
Fieldbus Controller 750-841
Fieldbus Controller
• 69