PEF80912HV14XT Infineon Technologies, PEF80912HV14XT Datasheet - Page 67

• Manufacturer Part Number: PEF80912HV14XT
• Manufacturer: Infineon Technologies

Specifications of PEF80912HV14XT

• Lead Free Status / Rohs Status: Compliant

1)
2)
3)
Table 19
Receive Path
Signal / (noise + total harmonic distortion)
DC-level at AD-output
Threshold of level detect
(measured between AIN and BIN with
respect to zero signal)
Input impedance AIN/BIN
Transmit Path
Signal / (noise + total harmonic distortion)
Common mode DC-level
Offset between AOUT and BOUT
Absolute peak voltage for a single +3 or -3
pulse measured between AOUT and
BOUT
Output impedance AOUT/BOUT:
Power-up
Power-down
1)
2)
3)
4)
Data Sheet
Requirement ITU-T I.430, chapter 8.5.1.1a): ’At all times except when transmitting a binary zero, the output
impedance , in the frequency range of 2kHz to 1 MHz, shall exceed the impedance indicated by the template
in Figure 11. The requirement is applicable with an applied sinusoidal voltage of 100 mV (r.m.s value)’
Requirement ITU-T I.430, chapter 8.5.1.1b): ’When transmitting a binary zero, the output impedance shall be
> 20 .’: Must be met by external circuitry.
Requirement ITU-T I.430, chapter 8.5.1.1b), Note: ’The output impedance limit shall apply for a nominal load
impedance (resistive) of 50
the peak pulse amplitude for loads equal to the nominal value +/- 10%. The peak amplitude shall be defined
as the the amplitude at the midpoint of a pulse. The limitation applies for pulses of both polarities.’
Test conditions: 1.4 Vpp differential sine wave as input on AIN/BIN with long range (low, critical range).
Versions PEF 8x913 with enhanced performance of the U-interface are tested with tightened limit values
The percentage of the "1 "-values in the PDM-signal.
Interpretation and test conditions: The sum of noise and total harmonic distortion, weighted with a low pass
filter 0 to 80 kHz, is at least 70 dB below the signal for an evenly distributed but otherwise random sequence
of +3, +1, -1, -3.
5)
U-Transceiver Characteristics
. The output impedance for each nominal load shall be defined by determining
1)
4)
59
Limit Values
min.
65
45
4
80
70
1.61
2.42
2)
typ.
50
5
1.65
2.5
0.8
3
Electrical Characteristics
PEF 80912/80913
max.
55
16 (PEF
80912)
9 (PEF
80913)
1.69
35
2.58
1.5
6
2001-03-29
Unit
dB
%
mV
peak
k
dB
V
mV
V
3)