FIN3386MTD Fairchild Semiconductor, FIN3386MTD Datasheet - Page 5

• Manufacturer Part Number: FIN3386MTD
• Manufacturer: Fairchild Semiconductor

Specifications of FIN3386MTD

• Number Of Elements: 4
• Number Of Receivers: 4
• Number Of Drivers: 28
• Input Type: CMOS/TTL
• Operating Supply Voltage (typ): 3.3V
• Differential Input High Threshold Voltage: 100mV
• Diff. Input Low Threshold Volt: -100mV
• Output Type: Deserializer
• Operating Supply Voltage (min): 3V
• Operating Supply Voltage (max): 3.6V
• Operating Temp Range: -10C to 70C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 56
• Package Type: TSSOP
• Lead Free Status / Rohs Status: Compliant

© 2003 Fairchild Semiconductor Corporation
FIN3383/3384/3385/3386 • Rev. 1.0.4
Transmitter and Receiver Power-Up / Power-Down Operation Truth Tables
The outputs of the transmitter remain in the high-impedance state until the power supply reaches 2V. The following
table shows the operation of the transmitter during power-up and power-down and operation of the /PwrDn pin.
Transmitter
Notes:
Receiver
Notes:
3.
4.
5.
6.
If the transmitter is powered up, /PwrDn is inactive HIGH, and the clock input goes to any state LOW, HIGH, or
high-impedance; the internal PLL goes to a known low frequency and stays until the clock starts normal
operation again.
If the input is terminated and un-driven (high-impedance) or shorted or open (fail-safe condition).
For /PwrDn or fail-safe condition the RxCLKOut pin goes LOW for Panel Link devices and HIGH for channel
link devices.
Shorted means (± inputs are shorted to each other, or ± inputs are shorted to each other and ground or V
either ± inputs are shorted to ground or V
still in the valid range (greater than 100mV) and V
recognized and the part responds normally.
TxCLKOut±
RxCLKOut
RxCLKIn±
TxCLKIn
/PwrDn
/PwrDn
TxOUT
RxOut
RxIn±
TxIN
V
V
CC
CC
Impedance
Impedance
Impedance
Impedance
Don’t Care
Don’t Care
Don’t Care
Don’t Care
LOW
LOW
High
High
High
High
<2V
<2V
Impedance
Impedance
Don’t Care
Don’t Care
Don’t Care
Don’t Care
CC
/PwrDn
PwrDn
Note 5
) with no other current/voltage sources (noise) applied. If the V
LOW
LOW
LOW
High
High
>2V
<2V
CM
5
is in the valid range (0V to 2.4V), the input signal is still
LOW/HIGH
Normal
Active
Active
Active
Active
Active
Active
Active
HIGH
HIGH
>2V
<2V
LOW/HIGH/
Impedance
Don’t Care
Last Valid
Note 3
Note 4
Note 5
Active
Active
HIGH
HIGH
State
High
>2V
<2V
Note 4
Note 4
Note 5
HIGH
HIGH
HIGH
>2V
<2V
www.fairchildsemi.com
Last Valid
Note 4
Note 4
Note 5
HIGH
State
>2V
<2V
CC
ID
, or
is