LAN9303-ABZJ SMSC, LAN9303-ABZJ Datasheet - Page 137

• Manufacturer Part Number: LAN9303-ABZJ
• Description: IC ETHER SW 3PORT 16BIT 56QFN
• Manufacturer: SMSC

Specifications of LAN9303-ABZJ

• Controller Type: Ethernet Switch Controller
• Interface: SMBus (2-Wire/I²C)
• Voltage - Supply: 3 V ~ 3.6 V
• Current - Supply: 190mA
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 56-QFN
• Product: Ethernet Switches
• Standard Supported: Yes
• Data Rate: 10 Mbps/100 Mbps
• Supply Voltage (max): 3.6 V
• Supply Voltage (min): 3 V
• Supply Current (max): 0.19 A (Typ)
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Mounting Style: SMD/SMT
• For Use With: 638-1095 - EVALUATION BOARD FOR LAN9303
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1082

Small Form Factor Three Port 10/100 Managed Ethernet Switch with Single MII/RMII/Turbo MII
Datasheet
SMSC LAN9303/LAN9303i
13.1
REGISTER BIT TYPE
RESERVED
NOTATION
RO/LH
NASR
WAC
WO
WC
RO
RC
SC
LH
SS
LL
W
R
Table 13.1
Many of these register bit notations can be combined. Some examples of this are shown below:
Register Nomenclature
R/W: Can be written. Will return current setting on a read.
R/WAC: Will return current setting on a read. Writing anything clears the bit.
describes the register bit attribute notation used throughout this document.
Read: A register or bit with this attribute can be read.
Read: A register or bit with this attribute can be written.
Read only: Read only. Writes have no effect.
Write only: If a register or bit is write-only, reads will return unspecified data.
Write One to Clear: writing a one clears the value. Writing a zero has no effect
Write Anything to Clear: writing anything clears the value.
Read to Clear: Contents is cleared after the read. Writes have no effect.
Latch Low: Clear on read of register.
Latch High: Clear on read of register.
Self-Clearing: Contents are self-cleared after the being set. Writes of zero have no
effect. Contents can be read.
Self-Setting: Contents are self-setting after being cleared. Writes of one have no
effect. Contents can be read.
Read Only, Latch High: Bits with this attribute will stay high until the bit is read. After
it is read, the bit will either remain high if the high condition remains, or will go low if
the high condition has been removed. If the bit has not been read, the bit will remain
high regardless of a change to the high condition. This mode is used in some Ethernet
PHY registers.
Not Affected by Software Reset. The state of NASR bits do not change on assertion
of a software reset.
Reserved Field: Reserved fields must be written with zeros to ensure future
compatibility. The value of reserved bits is not guaranteed on a read.
Table 13.1 Register Bit Types
DATASHEET
137
REGISTER BIT DESCRIPTION
Revision 1.4 (07-07-10)