TDA5231XT Infineon Technologies, TDA5231XT Datasheet - Page 71
TDA5231XT
Manufacturer Part Number
TDA5231XT
Description
Manufacturer
Infineon Technologies
Datasheet
1.TDA5231XT.pdf
(186 pages)
Specifications of TDA5231XT
Operating Temperature (min)
-40C
Operating Temperature (max)
105C
Operating Temperature Classification
Industrial
Product Depth (mm)
4.4mm
Product Length (mm)
9.7mm
Lead Free Status / Rohs Status
Compliant
- Current page: 71 of 186
- Download datasheet (4Mb)
The RSSI signal is used to determine the relative RF input signal power of a received
signal or data transmission, and for example, to estimate the transmitter distance.
RSSI can be read either from the analog output as described below, or digitally via the
peak detector registers, which are described in
To achieve a well-defined RSSI response, the offset and the gain of the RSSI generation
unit can be trimmed via the SFR control bits LIMGAIN and LIMOFFS as described later.
The bandwidth of the RSSI signal can be adapted to the data rate. It is controlled by the
SFR control bits AAFILT.
This RSSI Signal can be fed to the pin RSSI via a buffer amplifier. To enable this buffer
the SFR control bit RSSIMONE must be set.
Figure 32
RSSI is derived from four signals. Any of these four signals (RSSI+, RSSI-, REF+ and
REF-) may be routed to the pin RSSI. RSSI+ is the real RSSI signal derived from the
input signal voltage, while RSSI- is an internal offset, and REF+/- is the internal voltage
reference. The selection of the signal routed to pin RSSI is done by the SFR control bits
RSSIMTR.
Typical values are:
RSSI-...1.55 V, REF+...1.8 V, REF-...1.3 V; these values are not influenced by trimming.
The following figure shows the behavior of RSSI+ over an input signal power sweep. The
four curves show the trimming range in between minimum offset/maximum gain and
maximum offset/minimum gain, the typical RSSI+ using recommended default setting of
minimum offset / minimum gain (if RSSI trimming is not used), and the fourth curve
represents a typical trimmed RSSI+
Data Sheet
IF Path, RSSI
IFBUF-IN
IF-
Buffer-
Amp.
1
IFBUF-OUT
LIM-IN+
LIM-IN-
RSSI-Generation
67
IF-LIMITER
5
4
Chapter 2.4.8.3 RSSI Peak
2
RSSI
MUX
A
Functional Description
RSSIMONE
D
RSSIMTR
Version 4.0, 2007-06-01
To digital
FSK-Demodulator
and digital BB-
Processing
Detector.
TDA523x
Related parts for TDA5231XT
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
16-bit microcontroller with 2x2 KByte RAM
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
NPN silicon RF transistor
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
NPN silicon RF transistor
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
NPN silicon RF transistor
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
NPN silicon RF transistor
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
Si-MMIC-amplifier in SIEGET 25-technologie
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
IGBT Power Module
Manufacturer:
Infineon Technologies AG
Datasheet:
Part Number:
Description:
IC for switching-mode power supplies
Manufacturer:
Infineon Technologies AG
Datasheet: