AT90USB162 Atmel Corporation, AT90USB162 Datasheet - Page 25

• Manufacturer Part Number: AT90USB162
• Manufacturer: Atmel Corporation

Specifications of AT90USB162

• Flash (kbytes): 16 Kbytes
• Pin Count: 32
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 22
• Ext Interrupts: 21
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Uart: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 0.5
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 5
• Input Capture Channels: 1
• Pwm Channels: 4
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

6. System Clock and Clock Options
6.1
6.1.1
6.1.2
6.1.3
7707F–AVR–11/10
Clock Systems and their Distribution
CPU Clock – clk
I/O Clock – clk
Flash Clock – clk
I/O
Figure 6-1
need not be active at a given time. In order to reduce power consumption, the clocks to modules
not being used can be halted by using different sleep modes, as described in
ment and Sleep Modes” on page
Figure 6-1.
The CPU clock is routed to parts of the system concerned with operation of the AVR core.
Examples of such modules are the General Purpose Register File, the Status Register and the
data memory holding the Stack Pointer. Halting the CPU clock inhibits the core from performing
general operations and calculations.
The I/O clock is used by the majority of the I/O modules, like Timer/Counters, SPI, and USART.
The I/O clock is also used by the External Interrupt module, but note that some external inter-
rupts are detected by asynchronous logic, allowing such interrupts to be detected even if the I/O
clock is halted.
The Flash clock controls operation of the Flash interface. The Flash clock is usually active simul-
taneously with the CPU clock.
CPU
FLASH
PLL Clock
USB PLL
Prescaler
USB
X6
clk
clk
presents the principal clock systems in the AVR and their distribution. All of the clocks
clk
Pllin (8MHz)
USB (48MHz)
XTAL (2-16 MHz)
Clock Distribution
General I/O
Modules
41. The clock systems are detailed below.
clk
Oscillator
I/O
Crystal
System Clock
Control Unit
AVR Clock
Multiplexer
Prescaler
Switch
Clock
Clock
External Clock
Source clock
CPU Core
clk
clk
Reset Logic
CPU
FLASH
AT90USB82/162
Watchdog clock
Watchdog
Oscillator
Watchdog Timer
RAM
“Power Manage-
Calibrated RC
Flash and
EEPROM
Oscillator
25