AT90USB162 Atmel Corporation, AT90USB162 Datasheet - Page 48

• Manufacturer Part Number: AT90USB162
• Manufacturer: Atmel Corporation

Specifications of AT90USB162

• Flash (kbytes): 16 Kbytes
• Pin Count: 32
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 22
• Ext Interrupts: 21
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device
• Spi: 2
• Uart: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 0.5
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 2
• Output Compare Channels: 5
• Input Capture Channels: 1
• Pwm Channels: 4
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

9.4
48
External Reset
AT90USB82/162
device is kept in RESET after V
when V
Figure 9-2.
Figure 9-3.
An External Reset is generated by a low level on the RESET pin. Reset pulses longer than the
minimum pulse width (see
Shorter pulses are not guaranteed to generate a reset. When the applied signal reaches the
Reset Threshold Voltage – V
the Time-out period – t
Figure 9-4.
INTERNAL
INTERNAL
TIME-OUT
TIME-OUT
CC
RESET
RESET
RESET
RESET
V
V
decreases below the detection level.
CC
CC
CC
MCU Start-up, RESET Tied to V
MCU Start-up, RESET Extended Externally
External Reset During Operation
TOUT
– has expired.
V
V
V
Table
POT
POT
RST
RST
CC
t
– on its positive edge, the delay counter starts the MCU after
TOUT
rise. The RESET signal is activated again, without any delay,
9-1) will generate a reset, even if the clock is not running.
CC
V
RST
t
TOUT
7707F–AVR–11/10