AD9863 Analog Devices, AD9863 Datasheet - Page 27

• Manufacturer Part Number: AD9863
• Description: 12-Bit Mixed-Signal Front-End (MxFE® )Processor For Broadband Applications
• Manufacturer: Analog Devices

Specifications of AD9863

• Resolution (bits): 12bit
• # Chan: 2
• Sample Rate: 50MSPS
• Interface: Par
• Analog Input Type: Diff-Uni
• Ain Range: 2 V p-p
• Adc Architecture: Pipelined
• Pkg Type: CSP

Table 14. Mode Pin Names and Descriptions
Pin Name
ADC_LO_PWR
FD/HD (SDO)
12/ 24
SPI_Bus_Enable (SPI_CS)
Interp0 and Interp1
RxPWRDWN
TxPWRDWN
Tx/Rx
Description
ADC Low Power Mode Option. ADC_LO_PWR is latched during the rising edge of RESET.
Logic low results in ADC operation at nominal power mode.
Logic high results in the ADC consuming 40% less power than the nominal power mode.
For flex I/O configuration, this control applies only if the SPI bus is disabled. FD/HD (SDO) is latched during the
rising edge of RESET.
Logic low setting identifies that the DUT flex I/O port will be configured for half-duplex operation.
12/24 (IFACE2) is also latched during the rising edge of RESET to identify interleaved data mode or parallel
data mode.
Logic low indicates that the flex I/O will configure itself for parallel data mode.
Logic high indicates that the flex I/O will configure itself for interleaved data mode.
For flex I/O configuration, the 12/24 pin control applies only if the SPI bus is disabled and the device is
configured for HD mode. 12/24 is latched during the rising edge of RESET.
12/24 (IFACE2) is used to identify interleaved data mode or parallel data modes.
Logic low indicates that the flex I/O will configure itself for HD24 mode.
Logic high indicates that the flex I/O will configure itself for HD12 mode.
SPI_CS is latched during the rising edge of RESET.
Logic low results in the SPI being disabled; SPI_DIO, SPI_CLK, and SPI_SDO act as mode pins configuration pins.
Logic high results in the SPI being fully operational; some mode pins will be disabled.
Interpolation/PLL Factor Configuration. This control applies only if the SPI bus is disabled.
SPI_DIO (Interp1) and SPI_CLK (Interp0) configure the Tx path for 1× [00], 2× [01], or 4× [10] interpolation and
also enable the PLL of the same multiplication factor.
Power-Down Control. RxPWRDWN logic level controls the power-down function of the Rx path.
Logic low results in the Rx path operating at normal power levels.
Logic high disables the ADC clock and disables some bias circuitry to reduce power consumption.
Power-Down Control. TxPWRDWN logic level controls the power-down function of the Tx path.
Logic low results in the Tx path operating at normal power levels.
Logic high disables the DAC clocks and disables some bias circuitry to reduce power consumption.
Power-Down Control. Tx/Rx pin enables the appropriate Tx or Rx path in the half-duplex mode.
Logic low disables the Tx path and enables the Rx path.
Logic high disables the Rx path and enables the Tx path.
Rev. A | Page 27 of 40
AD9863