TMPM380FWFG Toshiba, TMPM380FWFG Datasheet - Page 456

• Manufacturer Part Number: TMPM380FWFG
• Manufacturer: Toshiba

Specifications of TMPM380FWFG

• Product Summaries: Summary
• Lead Free: Yes
• Rohs Compatible Product(s): Available
• Rom (kbytes): 128K
• Rom Type: Flash
• Ram (kbytes): 12K
• Number Of Pins: 100
• Package: LQFP(14×14)
• Vcc: 5V
• Cpu Mhz: 40
• Ssp (ch) Spi: 2
• I2c/sio (ch): 2
• Uart/sio (ch): 5
• Usb: -
• Can: -
• Ethernet: -
• External Bus Interface: N
• Cs/wait Controller (ch): -
• Dma Controller: 2
• 10-bit Da Converter: -
• 10-bit Ad Converter: -
• 12-bit Ad Converter: 18
• 16-bit Timer / Counter: 8
• Motor / Igbt Control: Y
• Real Time Clock: 1
• Watchdog Timer: Y
• Osc Freq Detect: Y
• Clock Gear: Y
• Low-power Hold Function: -
• Remote Control Interface: Y
• Hardware Cec Controller: -
• Comparators: -
• Low-voltage Detector: Y
• Etm Hardware Trace: 2-bit

SBInSR <AL>, <TRX>, <AAS> and <AD0> are tested to determine the processing required.
INTSBIn interrupt
Slave mode (<MST> = “0”)
In the slave mode, the SBI generates the INTSBIn interrupt request on four occasions: 1)
when the SBI has received any slave address from the master, 2) when the SBI has
received a general-call address, 3) when the received slave address matches its own
address, and 4) when a data transfer has been completed in response to a general-call.
Also, if the SBI detects Arbitration Lost in the master mode, it switches to the slave mode.
Upon the completion of data word transfer in which Arbitration Lost is detected, the INTSBIn
interrupt request is generated, <PIN> is cleared to “0,” and the SCL pin is pulled to the “L”
level. When data is written to or read from SBInDBR or when <PIN> is set to “1,” the SCL
pin is released after a period of t
In the slave mode, the normal slave mode processing or the processing as a result of
Arbitration Lost is carried out.
Table 15-2 shows the slave mode states and required processing.
Example: When the received slave address matches the SBI's own address and the
direction bit is “1” in the slave receiver mode.
if TRX = 0
Then go to other processing
if AL = 1
Then go to other processing
if AAS = 0
Then go to other processing
(Note) X: Don’t care
SBInCR1 ← X X X 1 0 X X X
SBInDBR ← X X X X 0 X X X
TMPM380/M382 - 27 / 41 -
LOW
.
Sets the number of bits to be transmitted.
Sets the transmit data.
TMPM380/M382