ep1s25 Altera Corporation, ep1s25 Datasheet - Page 102
![no-image](/images/manufacturer_photos/0/0/41/altera_corporation_sml.jpg)
ep1s25
Manufacturer Part Number
ep1s25
Description
Stratix Device Family Data Sheet
Manufacturer
Altera Corporation
Datasheet
1.EP1S25.pdf
(276 pages)
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
ep1s25B672C6N
Manufacturer:
AD
Quantity:
1 001
Company:
Part Number:
ep1s25B672C6N
Manufacturer:
ALTERA
Quantity:
210
Company:
Part Number:
ep1s25B672C7
Manufacturer:
ALTERA
Quantity:
852
PLLs & Clock Networks
2–88
Stratix Device Handbook, Volume 1
Clock Multiplication & Division
Each Stratix device enhanced PLL provides clock synthesis for PLL
output ports using m/(n × post-scale counter) scaling factors. The input
clock is divided by a pre-scale divider, n, and is then multiplied by the m
feedback factor. The control loop drives the VCO to match f
Each output port has a unique post-scale counter that divides down the
high-frequency VCO. For multiple PLL outputs with different
frequencies, the VCO is set to the least common multiple of the output
frequencies that meets its frequency specifications. Then, the post-scale
dividers scale down the output frequency for each output port. For
example, if output frequencies required from one PLL are 33 and 66 MHz,
set the VCO to 330 MHz (the least common multiple in the VCO’s range).
There is one pre-scale counter, n, and one multiply counter, m, per PLL,
with a range of 1 to 512 on each. There are two post-scale counters (l) for
regional clock output ports, four counters (g) for global clock output
ports, and up to four counters (e) for external clock outputs, all ranging
from 1 to 1024 with a 50% duty cycle setting. The post-scale counters
range from 1 to 512 with any non-50% duty cycle setting. The Quartus II
software automatically chooses the appropriate scaling factors according
to the input frequency, multiplication, and division values entered.
Clock Switchover
To effectively develop high-reliability network systems, clocking schemes
must support multiple clocks to provide redundancy. For this reason,
Stratix device enhanced PLLs support a flexible clock switchover
capability.
circuit.The switchover circuit is configurable, so you can define how to
implement it. Clock-sense circuitry automatically switches from the
primary to secondary clock for PLL reference when the primary clock
signal is not present.
Figure 2–53
shows a block diagram of the switchover
Altera Corporation
IN
× (m/n).
July 2005