mc68hc08az60 Freescale Semiconductor, Inc, mc68hc08az60 Datasheet - Page 230

• Manufacturer Part Number: mc68hc08az60
• Description: M68hc08 Family Of 8-bit Microcontroller Units Mcus
• Manufacturer: Freescale Semiconductor, Inc

Serial Peripheral Interface Module (SPI)
MC68HC08AZ60 — Rev 1.0
230
Resetting the SPI
For a slave, the transmit data buffer allows back-to-back transmissions
to occur without the slave having to time the write of its data between the
transmissions. Also, if no new data is written to the data buffer, the last
value contained in the shift register will be the next data word
transmitted.
Any system reset completely resets the SPI. Partial reset occurs
whenever the SPI enable bit (SPE) is low. Whenever SPE is low, the
following occurs:
The following additional items are reset only by a system reset:
By not resetting the control bits when SPE is low, the user can clear SPE
between transmissions without having to reset all control bits when SPE
is set back to high for the next transmission.
By not resetting the SPRF, OVRF, and MODF flags, the user can still
service these interrupts after the SPI has been disabled. The user can
disable the SPI by writing 0 to the SPE bit. The SPI also can be disabled
by a mode fault occurring in an SPI that was configured as a master with
the MODFEN bit set.
Freescale Semiconductor, Inc.
•
•
•
•
•
•
•
•
For More Information On This Product,
The SPTE flag is set.
Any transmission currently in progress is aborted.
The shift register is cleared.
The SPI state counter is cleared, making it ready for a new
complete transmission.
All the SPI port logic is defaulted back to being general-purpose
I/O.
All control bits in the SPCR register
All control bits in the SPSCR register (MODFEN, ERRIE, SPR1,
and SPR0)
The status flags SPRF, OVRF, and MODF
Serial Peripheral Interface Module (SPI)
Go to: www.freescale.com
MOTOROLA
20-spi