xr16l2552im Exar Corporation, xr16l2552im Datasheet - Page 28

• Manufacturer Part Number: xr16l2552im
• Description: Industry Smallest Package Uart With 2.25v To 5.5v Operation
• Manufacturer: Exar Corporation

XR16L2552
2.25V TO 5.5V DUART WITH 16-BYTE FIFO
LCR[3]: TX and RX Parity Select
Parity or no parity can be selected via this bit. The parity bit is a simple way used in communications for data
integrity check. See
•
•
LCR[4]: TX and RX Parity Select
If the parity bit is enabled with LCR bit-3 set to a logic 1, LCR BIT-4 selects the even or odd parity format.
•
•
LCR[5]: TX and RX Parity Select
If the parity bit is enabled, LCR BIT-5 selects the forced parity format.
•
•
•
LCR[6]: Transmit Break Enable
When enabled, the Break control bit causes a break condition to be transmitted (the TX output is forced to a
“space’, logic 0, state). This condition remains, until disabled by setting LCR bit-6 to a logic 0.
•
•
LCR[7]: Baud Rate Divisors Enable
Baud rate generator divisor (DLL/DLM) enable.
•
•
The MCR register is used for controlling the serial/modem interface signals or general purpose inputs/outputs.
4.8
Logic 0 = No parity.
Logic 1 = A parity bit is generated during the transmission while the receiver checks for parity error of the
data character received.
Logic 0 = ODD Parity is generated by forcing an odd number of logic 1’s in the transmitted character. The
receiver must be programmed to check the same format (default).
Logic 1 = EVEN Parity is generated by forcing an even number of logic 1’s in the transmitted character. The
receiver must be programmed to check the same format.
LCR[5] = logic 0, parity is not forced (default).
LCR[5] = logic 1 and LCR[4] = logic 0, parity bit is forced to a logical 1 for the transmit and receive data.
LCR[5] = logic 1 and LCR[4] = logic 1, parity bit is forced to a logical 0 for the transmit and receive data.
Logic 0 = No TX break condition (default).
Logic 1 = Forces the transmitter output (TX) to a “space”, logic 0, for alerting the remote receiver of a line
break condition.
Logic 0 = Data registers are selected (default).
Logic 1 = Divisor latch registers are selected.
Modem Control Register (MCR) or General Purpose Outputs Control - Read/Write
Table 11
LCR B
for parity selection summary below.
X
0
0
1
1
IT
-5 LCR B
T
ABLE
X
0
1
0
1
IT
-4 LCR B
11: P
ARITY SELECTION
28
0
1
1
1
1
IT
-3
Force parity to mark,
P
Forced parity to
ARITY SELECTION
Even parity
Odd parity
space, “0”
No parity
“1”
xr
REV. 1.1.1