am41dl3208gt85it Meet Spansion Inc., am41dl3208gt85it Datasheet - Page 26

• Manufacturer Part Number: am41dl3208gt85it
• Description: 32 Mbit 4 M ? 8-bit/2 M ? 16-bit Cmos 3.0 Volt-only, Simultaneous Operation Flash Memory And 8 Mbit 1 M ? 8-bit/512 K ? 16-bit Static Ram Preliminary
• Manufacturer: Meet Spansion Inc.

CE#f and WE# must be a logical zero while OE# is a
logical one.
Power-Up Write Inhibit
If WE# = CE#f = V
the device does not accept commands on the rising
edge of WE#. The internal state machine is automati-
cally reset to reading array data on power-up.
COMMON FLASH MEMORY INTERFACE
(CFI)
The Common Flash Interface (CFI) specification out-
lines device and host system software interrogation
handshake, which allows specific vendor-specified
software algorithms to be used for entire families of
devices. Software support can then be device-inde-
pendent, JEDEC ID-independent, and forward- and
backward-compatible for the specified flash device
families. Flash vendors can standardize their existing
interfaces for long-term compatibility.
February 13, 2002
(Word Mode)
Addresses
10h
12h
13h
14h
15h
16h
17h
18h
19h
1Ah
11h
(Byte Mode)
IL
Addresses
and OE# = V
2Ah
2Ch
2Eh
20h
22h
24h
26h
28h
30h
32h
34h
IH
Table 11. CFI Query Identification String
during power up,
0051h
0052h
0059h
0002h
0000h
0040h
0000h
0000h
0000h
0000h
0000h
Data
P R E L I M I N A R Y
Am41DL3208G
Query Unique ASCII string “QRY”
Primary OEM Command Set
Address for Primary Extended Table
Alternate OEM Command Set (00h = none exists)
Address for Alternate OEM Extended Table (00h = none exists)
This device enters the CFI Query mode when the sys-
tem writes the CFI Query command, 98h, to address
55h in word mode (or address AAh in byte mode), any
time the device is ready to read array data. The sys-
tem can read CFI information at the addresses given
in Tables 11–14. To terminate reading CFI data, the
system must write the reset command. The CFI Query
mode is not accessible when the device is executing
an Embedded Program or embedded erase algorithm.
The system can also write the CFI query command
when the device is in the autoselect mode. The device
enters the CFI query mode, and the system can read
CFI data at the addresses given in Tables 11–14. The
system must write the reset command to return the de-
vice to the autoselect mode.
For further information, please refer to the CFI Specifi-
cation and CFI Publication 100, available via the
World Wide We b at ht tp: //ww w. am d.co m/ prod -
ucts/nvd/overview/cfi.html. Alternatively, contact an
AMD representative for copies of these documents.
Description
25