lc890561w Sanyo Semiconductor Corporation, lc890561w Datasheet - Page 25

• Manufacturer Part Number: lc890561w
• Description: Cmos Digital Audio Interface Receiver With Built-in Data Buffer Memory
• Manufacturer: Sanyo Semiconductor Corporation

• DTMA[4:0], DTMB[3:0] and DTMC[2:0] commands have the same address. Therefore, they can be set up together.
• Each command setting value is assigned to output data according to the sampling frequency of input data.
• Delay time is set up with the number of frames which is obtained by multiplying the sampling frequency calculation
• Delay time can be freely switched within the range where the setup is possible.
• This setup is continued until it is canceled (delayed 0ms, non delay).
• This function is not performed when mode 4, “Input fs free mode B”, by MODE0 and MODE1 is set. Even the above
13.1.2 Output Data Delay Setup of SDIN Input Data (DTMX[4:0], DTMY[3:0])
• Output data delay of SDIN input data is set up by DTMX[4:0] and DTMY[3:0] commands.
• SDIN input data needs to synchronize with BCK and LRCK output clocks. Therefore, the sampling frequency of
• Delay time can be freely switched within the range where the setup is possible.
• This setup is continued until it is canceled (delayed 0ms, non delay).
• The following delay time is performed when mode 4, “Input fs free mode B”, by MODE0 and MODE1 is set.
setting is set, it will be invalid.
value of input data by the setting value of DTMA[4:0], DTMB[3:0] and DTMC[2:0] commands.
SDIN data is decided by setup of XSEL (XIN input clock frequency). In other word, input data is either 48kHz or
96kHz, and uses a setup of either DTMX[4:0] or DTMY[3:0] commands.
Delay time = {(256fs × delay time of DTMX [4:0] or DTMY [3:0]) / XIN input clock}
(“○” can be set, “ ” maximum delay time is set)
Table 13.2 Delay Time Setup of Output Data for the SDIN Input Data
Delay time
100m
110m
120m
130m
140m
150m
160m
170m
180m
190m
200m
210m
220m
230m
240m
250m
(sec)
Max.
10m
20m
30m
40m
50m
60m
70m
80m
90m
0
LC890561W
(DTMX[4:0])
SDIN input data fs (Hz) and setting commands
48k
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
○
See section “ 14.5.2 Details of Write
(DTMY[3:0])
Commands ”
96k
○
○
○
○
○
○
○
○
○
○
○
○
○
No8226-25/47