SC18IM700IPW PHILIPS [NXP Semiconductors], SC18IM700IPW Datasheet - Page 19

no-image

SC18IM700IPW

Manufacturer Part Number
SC18IM700IPW
Description
Master I-2C - bus controller with UART interface
Manufacturer
PHILIPS [NXP Semiconductors]
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
SC18IM700IPW
Manufacturer:
ROHM
Quantity:
16 562
Part Number:
SC18IM700IPW
Manufacturer:
NXP/恩智浦
Quantity:
20 000
Part Number:
SC18IM700IPW,112
Manufacturer:
Renesas
Quantity:
51
Company:
Part Number:
SC18IM700IPW,128
Quantity:
732
Company:
Part Number:
SC18IM700IPW/S8
Quantity:
239
Part Number:
SC18IM700IPW/S8HP
0
Philips Semiconductors
15. Abbreviations
16. Revision history
Table 15:
SC18IM700_1
Product data sheet
Document ID
SC18IM700_1
Revision history
Release date
20060228
[4]
[5]
[6]
[7]
[8]
[9]
Table 14:
Acronym
ASCII
FIFO
GPIO
I
RXFIFO
TXFIFO
UART
2
C-bus
These packages are not suitable for wave soldering. On versions with the heatsink on the bottom side, the
solder cannot penetrate between the printed-circuit board and the heatsink. On versions with the heatsink
on the top side, the solder might be deposited on the heatsink surface.
If wave soldering is considered, then the package must be placed at a 45 angle to the solder wave
direction. The package footprint must incorporate solder thieves downstream and at the side corners.
Wave soldering is suitable for LQFP, QFP and TQFP packages with a pitch (e) larger than 0.8 mm; it is
definitely not suitable for packages with a pitch (e) equal to or smaller than 0.65 mm.
Wave soldering is suitable for SSOP, TSSOP, VSO and VSSOP packages with a pitch (e) equal to or larger
than 0.65 mm; it is definitely not suitable for packages with a pitch (e) equal to or smaller than 0.5 mm.
Image sensor packages in principle should not be soldered. They are mounted in sockets or delivered
pre-mounted on flex foil. However, the image sensor package can be mounted by the client on a flex foil by
using a hot bar soldering process. The appropriate soldering profile can be provided on request.
Hot bar soldering or manual soldering is suitable for PMFP packages.
Abbreviations
Data sheet status
Product data sheet
Description
American Standard Code for Information Interchange
First In, First Out
General Purpose Input/Output
Inter Integrated Circuit bus
Receive FIFO
Transmit FIFO
Universal Asynchronous Receiver/Transmitter
Rev. 01 — 28 February 2006
Change notice
-
Master I
2
C-bus controller with UART interface
Doc. number
-
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
SC18IM700
Supersedes
-
19 of 21

Related parts for SC18IM700IPW