SC18IM700IPW PHILIPS [NXP Semiconductors], SC18IM700IPW Datasheet - Page 9

• Manufacturer Part Number: SC18IM700IPW
• Description: Master I-2C - bus controller with UART interface
• Manufacturer: PHILIPS [NXP Semiconductors]

Philips Semiconductors
SC18IM700_1
Product data sheet
9.2.2.1 Quasi-bidirectional output configuration
9.2.1 Baud Rate Generator (BRG)
9.2.2 Programmable port configuration (PortConf1 and PortConf2)
9.2 Register descriptions
The baud rate generator is an 8-bit counter that generates the data rate for the transmitter
and the receiver. The rate is programmed through the BRG register and the baud rate can
be calculated as follows:
Remark: To calculate the baud rate the values in the BRG registers must first be
converted from hex to decimal.
Remark: For the new baud rate to take effect, both BRG0 and BRG1 must be written in
sequence (BRG0, BRG1) with new values. The new baud rate will be in effect once BRG1
is written.
GPIO port 0 to port 7 may be configured by software to one of four types. These are:
quasi-bidirectional, push-pull, open-drain, and input-only. Two bits are used to select the
desired configuration for each port pin. PortConf1 is used to select the configuration for
GPIO3 to GPIO0, and PortConf2 is used to select the configuration for GPIO7 to GPIO4.
A port pin has Schmitt triggered input that also has a glitch suppression circuit.
Table 5:
Quasi-bidirectional output type can be used as both an input and output without the need
to reconfigure the port. This is possible because when the port outputs a logic HIGH, it is
weakly driven, allowing an external device to pull the pin LOW. When the pin is driven
LOW, it is driven strongly and able to sink a fairly large current. These features are
somewhat similar to an open-drain output except that there are three pull-up transistors in
the quasi-bidirectional output that serve different purposes.
The SC18IM700 is a 3 V device, but the pins are 5 V tolerant. In quasi-bidirectional mode,
if a user applies 5 V on the pin, there will be a current flowing from the pin to V
extra power consumption. Therefore, applying 5 V in quasi-bidirectional mode is
discouraged.
A quasi-bidirectional port pin has a Schmitt triggered input that also has a glitch
suppression circuit.
Baud rate
GPIOx.1
0
0
1
1
=
Port configurations
GPIOx.0
0
1
0
1
--------------------------------------------------
16
+
7.3728 10
BRG1 BRG0
Rev. 01 — 28 February 2006
Port configuration
quasi-bidirectional output configuration
input-only configuration
push-pull output configuration
open-drain output configuration
6
Master I
2
C-bus controller with UART interface
© Koninklijke Philips Electronics N.V. 2006. All rights reserved.
SC18IM700
DD
, causing
9 of 21