R5S72611 RENESAS [Renesas Technology Corp], R5S72611 Datasheet - Page 860

• Manufacturer Part Number: R5S72611
• Description: 32-Bit RISC Microcomputer SuperHTM RISC engine Family / SH7260 Series
• Manufacturer: RENESAS [Renesas Technology Corp]

Section 19 Controller Area Network (RCAN-ET) [R5S72611] [R5S72613]
Note: After issuing a Halt request the CPU is not allowed to set TXPR or TXCR or clear MCR1
Note: Transition into or recovery from Halt mode, is only possible if the BCR1 and BCR0
Bit 0 — Reset Request (MCR0): Controls resetting of the RCAN-ET module. When this bit is
changed from '0' to '1' the RCAN-ET controller enters its reset routine, re-initialising the internal
logic, which then sets GSR3 and IRR0 to notify the reset mode. During a re-initialisation, all user
registers are initialised.
RCAN-ET can be re-configured while this bit is set. This bit has to be cleared by writing a '0' to
join the CAN bus. After this bit is cleared, the RCAN-ET module waits until it detects 11
recessive bits, and then joins the CAN bus. The Baud Rate needs to be set up to a proper value in
order to sample the value on the CAN Bus.
After Power On Reset, this bit and GSR3 are always set. This means that a reset request has been
made and RCAN-ET needs to be configured.
The Reset Request is equivalent to a Power On Reset but controlled by Software.
Rev. 2.00 Sep. 07, 2007 Page 828 of 1312
REJ09B0320-0200
Bit 1: MCR1
0
1
Bit 0: MCR0
0
1
until the transition to Halt mode is completed (notified by IRR0 and GSR4). After MCR1
is set this can be cleared only after entering Halt mode or through a reset operation (SW or
HW).
registers are configured to a proper Baud Rate.
Description
Clear Halt request (Initial value)
Halt mode transition request
Description
Clear Reset Request
CAN Interface reset mode transition request (Initial value)