WIZ610wi WIZnet, WIZ610wi Datasheet - Page 52

• Manufacturer Part Number: WIZ610wi
• Description: WiFi / 802.11 Modules 802.11B/G WIFI MOD
• Manufacturer: WIZnet

Specifications of WIZ610wi

• Rohs: yes
• Protocol Supported: 802.11 b/g
• Frequency Band: 2.4 GHz
• Data Rate: 11 Mbps, 54 Mbps
• Interface Type: Ethernet, UART
• Transmit Power (max): 16 dBm
• Antenna Connector Type: U.FL
• Operating Supply Voltage: 5 V
• Supply Current Transmitting: 480 mA
• Supply Current Receiving: 480 mA
• Maximum Operating Temperature: + 70 C
• Dimensions: 39 mm x 32 mm x 4.7 mm
• Minimum Operating Temperature: - 30 C
• Modulation Technique: DSSS, OFDM
• Security: AES, WEP, WPA, WPA2

Figure 40. Device Terminal Program
Device Terminal is a program which integrates both serial and network communications into
one user interface so that you can test your WIZnet gateway module easily.
As shown in above Figure, the upper part of the program allows you to configure your serial
setting of WIZ610wi. By clicking the “Open” button, serial communication is enabled.
The lower part of the program allows you to configure the network settings. You can test
both TCP Client and TCP Server modes at the same time. If the Server Mode is enabled,
Device Terminal will operate as server mode, and the WIZ610wi module will work as client
mode. The PC where the Device Terminal is operating will work as a server, the IP address of
the PC should be set as Server IP of the module. If Server mode is not checked, Device
Terminal will operate as client mode, and the module as server. For the IP address and port,
please input your IP address and port number of WIZ610wi and click the “Connect” button
to start a network communication.
When serial and network terminals are connected, input any character in the Data Input
window and click “Send” button. You can check the data is transferred into the another
window.
44