MAX11014BGTM+ Maxim Integrated, MAX11014BGTM+ Datasheet - Page 9

• Manufacturer Part Number: MAX11014BGTM+
• Description: Special Purpose Amplifiers Auto RF MESFET Amp Drain-Current Cntrlr
• Manufacturer: Maxim Integrated
• Series: MAX11014, MAX11015r

Specifications of MAX11014BGTM+

• Rohs: yes
• Common Mode Rejection Ratio (min): 90 dB
• Operating Supply Voltage: 0.5 V to 11 V
• Supply Current: 2.8 mA
• Maximum Power Dissipation: 2162.2 mW
• Maximum Operating Temperature: + 105 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Package / Case: TQFN-48
• Available Set Gain: 13.98 dB

MISCELLANEOUS TIMING CHARACTERISTICS (continued)
Note 1: All current-sense amplifier specifications are tested after a current-sense calibration (valid when drain current = 0mA). See
Note 2: The hardware configuration register’s CH_OCM1 and CH_OCM0 bits are set to 0. See Table 10a. The max specification is
Note 3: Guaranteed by design. Not production tested.
Note 4: At power-on reset, the output safe switch is closed. See the ALMHCFG (Read/Write) section.
Note 5: Integral nonlinearity is the deviation of the analog value at any code from its theoretical value after the gain and offset errors
Note 6: Offset nulled.
Note 7: Absolute range for analog inputs is from 0 to V
Note 8: Device and sensor at the same temperature. Verified by the current ratio (see the Temperature Measurements section).
Note 9: All timing specifications referred to V
Note 10: D
Note 11: A master device must provide a hold time of at least 300ns for the SDA signal (referred to V
Note 12: t
Note 13: C
Note 14: An appropriate bus pullup resistance must be selected depending on board capacitance. For more information, refer to the
Note 15: Input filters on the SDA and SCL inputs suppress noise spikes less than 50ns.
Note 16: When a command is written to the serial interface, it is passed to the internal oscillator clock to be executed. There is a
Note 17: This is the minimum time from the end of a command before CNVST should be asserted. The time allows for the data from
RCS Error vs. GATE Current in the Typical Operating Characteristics . The calibration is valid only at one temperature and
supply voltage and must be repeated if either the temperature or supply voltage changes.
limited by tester limitations.
have been calibrated out.
before it goes to tri-state.
the undefined region of SCL’s falling edge.
linearly interpolated.
I
small synchronization delay before the new value is written to the appropriate register. If the user attempts to read the new
value back before t
the preceding write to arrive and set up the chip in preparation for the CNVST. The time need only be observed when the
write affects the ADC controls. Failure to observe this time may lead to incorrect conversions (for example, conversion of
the wrong ADC channel).
R
2
OUT
B
C documentation on the Philips website.
and t
= total capacitance of one bus line in pF. For bus loads between 100pF and 400pF, the timing parameters should be
goes into tri-state mode after the CS rising edge. Keep CS low long enough for the DOUT value to be sampled
F
measured between 0.3 x DV
_______________________________________________________________________________________
RDBK
, no harm will be caused to the data, but the read command may not yet show the new value.
Automatic RF MESFET Amplifier
IH
DD
or V
and 0.7 x DV
IL
levels.
AVDD
.
DD
Drain-Current Controllers
.
IL
of the SCL signal) to bridge
9