ICB1FL02G Infineon Technologies, ICB1FL02G Datasheet - Page 3

• Manufacturer Part Number: ICB1FL02G
• Description: IC SMART BALLAST CONTROL PDSO-18
• Manufacturer: Infineon Technologies
• Type: PFC/Ballast Controllerr

Specifications of ICB1FL02G

• Frequency: 20 ~ 100 kHz
• Current - Supply: 650µA
• Voltage - Supply: 10.5 V ~ 17.5 V
• Operating Temperature: -25°C ~ 125°C
• Package / Case: DSO-18
• Packages: PG-DSO-18
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Output: -
• Lead Free Status / Rohs Status: Details
• Other names: ICB1FL02GXT; SP000204703

Smart Ballast Control IC for
Fluorescent Lamp Ballasts
Datasheet Version 2.1
Product Highlights
• Lowest Count of external Components
• HV-Driver with coreless Transformer Technology
• Improved Reliability and minimized Spread due to
Features PFC
•
•
•
•
Features Lamp Ballast Inverter
•
•
•
•
•
•
•
•
•
Type
ICB1FL02G
90 ... 270 V AC
90 ... 270 V AC
digital and optimized analog control functions
Discontinuous Conduction Mode PFC
Integrated Compensation of PFC Control Loop
Adjustable PFC Current Limitation
Adjustable PFC Bus Voltage
Supports Restart after Lamp Removal and End-of-
Life Detection in Multi-Lamp Topologies
End-of-Life (EOL) detected by adjustable
± Thresholds of sensed lamp voltage
Rectifier Effect detected by ratio of ± Amplitude of
Lamp Voltage
Detection of different capacitive Mode Operations
Adjustable Inverter Overcurrent Shutdown
Self-adaption of Ignition Time from 40ms to 235ms
Parameters adjustable by Resistors only
Pb-free lead plating; RoHS compliant
Halogen-free mould compound, WEEE compliant
PFCZCD
PFCZCD
PFCGD
PFCGD
PFCVS
PFCVS
PFCCS
PFCCS
3
Description
The Smart Ballast IC is designed to control a Fluorescent
Lamp Ballast including a Discontinuous Conduction
Mode Power Factor Correction (PFC), a lamp Inverter
Control and a High Voltage Level Shift Half-Bridge
Driver.
The application requires a minimum of external
components. There are integrated low pass filters and an
internal compensation for the PFC voltage loop control.
Preheating time is adjustable by a single resistor only in
the range between 0 and 2000ms. In the same way the
preheating frequency and run frequency are set by
resistors only. The control concept covers requirements
for T5 lamp ballasts such as detection of end-of-life and
detection of capacitive mode operation and other
protection measures even in multilamp topologies.
ICB1FL02G is easy to use and easy to design and
therefore a basis for a cost effective solution for
fluorescent lamp ballasts.
HSGD
HSGD
HSVCC
HSVCC
HSGND
HSGND
LSGD
LSGD
LSCS
LSCS
Package
PG-DSO-18-2
PG-DSO-18-2
PG-DSO-18-1
ICB1FL02G
September 2008