DTMFDECODER-RD Silicon Laboratories Inc, DTMFDECODER-RD Datasheet - Page 125

• Manufacturer Part Number: DTMFDECODER-RD
• Description: KIT REF DESIGN DTMF DECODER
• Manufacturer: Silicon Laboratories Inc

Specifications of DTMFDECODER-RD

• Mfg Application Notes: DTMF Decoder Ref Design AppNote
• Main Purpose: Telecom, DTMF Decoder
• Embedded: No
• Utilized Ic / Part: C8051F300
• Primary Attributes: 8kHz Sampling Rate ADC
• Secondary Attributes: 16 Goertzel Filters
• Processor To Be Evaluated: C8051F300
• Interface Type: RS-232
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant
• Other names: 336-1283

13.5.3. Slave Receiver Mode
Serial data is received on SDA and the clock is received on SCL. When slave events are enabled (INH =
0), the interface enters Slave Receiver Mode when a START followed by a slave address and direction bit
(WRITE in this case) is received. Upon entering Slave Receiver Mode, an interrupt is generated and the
ACKRQ bit is set. Software responds to the received slave address with an ACK, or ignores the received
slave address with a NACK. If the received slave address is ignored, slave interrupts will be inhibited until
the next START is detected. If the received slave address is acknowledged, zero or more data bytes are
received. Software must write the ACK bit after each received byte to ACK or NACK the received byte. The
interface exits Slave Receiver Mode after receiving a STOP. Note that the interface will switch to Slave
Transmitter Mode if SMB0DAT is written while an active Slave Receiver; see
this procedure. Figure 13.7 shows a typical Slave Receiver sequence. Two received data bytes are shown,
though any number of bytes may be received. Notice that the ‘data byte transferred’ interrupts occur
before the ACK cycle in this mode.
S
Received by SMBus
Interface
Transmitted by
SMBus Interface
Figure 13.7. Typical Slave Receiver Sequence
SLA
Interrupt
W
A
Data Byte
Rev. 2.9
Interrupt
A
S = START
P = STOP
A = ACK
R = READ
SLA = Slave Address
Data Byte
C8051F300/1/2/3/4/5
Interrupt
A
Section 13.5.4
Interrupt
P
for details on
125