DM330023 Microchip Technology, DM330023 Datasheet - Page 27

• Manufacturer Part Number: DM330023
• Description: BOARD DEV DSPICDEM MCHV
• Manufacturer: Microchip Technology
• Series: dsPICDEM™r

Specifications of DM330023

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, Other
• Utilized Ic / Part: dsPIC33F
• Primary Attributes: AC Induction (ACIM) Motors, Brushless DC (BLDC) Motors, Permanent Magnet Synchronous (PMSM) Motors
• Secondary Attributes: Power Factor Corrected (PFC)
• Processor To Be Evaluated: dsPICDEM
• Processor Series: dsPIC DSC
• Interface Type: RS-232, USB
• Operating Supply Voltage: 90 V to 265 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

 2009 Microchip Technology Inc.
4. Select Debugger>Program to program the application code into the dsPIC33F
2.4.4.1
The Starter Kit executes in either real-time (Run) or steps (Step Into, Step Over, and
Animate) real-time execution occurs when you select Run in MPLAB IDE. Once the
device code is halted, either by Halt or a breakpoint, you can step.
Toolbar buttons can be used for quick access to commonly used debug operations.
Refer to Section 3.3 “Running the Example Application” in the “MPLAB Starter Kit
for dsPIC
To see how these options function, do the following:
1. Select Debugger>Reset>Processor Reset or click the Reset button to reset the
2. Select Debugger>Run or click the Run button. Observe how the application
3. Select Debugger>Halt or click the Halt button to stop the program execution. A
4. Select Debugger>Step Into or click the Step Into button to step the program exe-
5. Select Debugger>Reset>Processor Reset click the Reset button to reset the
Note:
Note:
DCS device on the Starter Kit. The debug programming progress will be visible
in the Starter Kit tab of the Output window.
program.
operates.
green solid arrow will mark the line of code in the File window where the program
halted.
cution once. The green solid arrow will move down one line of code in the File
window. Repeatedly click the button to step through the code.
program again. The arrow will disappear, meaning the device is reset.
®
RUNNING THE APPLICATION
Debug executive code is automatically programmed in the upper program
memory of the Starter Kit device when the Starter Kit is selected as a
debugger. Debug code must be programmed into the target device to use
the in-circuit debugging capabilities of the Starter Kit.
All the peripherals are frozen when the “Halt” button is pressed to stop the
program execution.
Digital Signal Controllers User’s Guide” (DS51700).
DS70605A-page 21