DM330023 Microchip Technology, DM330023 Datasheet - Page 29

• Manufacturer Part Number: DM330023
• Description: BOARD DEV DSPICDEM MCHV
• Manufacturer: Microchip Technology
• Series: dsPICDEM™r

Specifications of DM330023

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, Other
• Utilized Ic / Part: dsPIC33F
• Primary Attributes: AC Induction (ACIM) Motors, Brushless DC (BLDC) Motors, Permanent Magnet Synchronous (PMSM) Motors
• Secondary Attributes: Power Factor Corrected (PFC)
• Processor To Be Evaluated: dsPICDEM
• Processor Series: dsPIC DSC
• Interface Type: RS-232, USB
• Operating Supply Voltage: 90 V to 265 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

FIGURE 2-8:
 2009 Microchip Technology Inc.
2.4.4.2.2
To set a breakpoint in code:
1. Double click the gutter: Double click in the window gutter next to the line of code
2. Pop-up Menu: Place the cursor over the line of code where you want the break-
3. Breakpoint Dialog: Open the Breakpoint dialog (Debugger>Breakpoints) to set,
A breakpoint set in code will appear as a red hexagon with a “B” as shown in Figure 2-8.
BREAKPOINT EXAMPLE
Note:
where you want the breakpoint. Double click again to remove the breakpoint.
point. Then, right-click to pop up a menu and select Set Breakpoint. Once a
breakpoint is set, “Set Breakpoint” will become “Remove Breakpoint” and “Dis-
able breakpoint”. Other options on the popup menu under Breakpoints are for
deleting, enabling, or disabling all breakpoints.
delete, enable, or disable breakpoints. See the MPLAB IDE Help for more
information on this dialog.
Double click must be set up for breakpoints. Select the Edit>Properties, and
click the ASM/C/BAS File Type tab, and then select the “Double-click Tog-
gles Breakpoint” check box.
Using Breakpoints and Mouseovers
DS70605A-page 23