DM330023 Microchip Technology, DM330023 Datasheet - Page 3

• Manufacturer Part Number: DM330023
• Description: BOARD DEV DSPICDEM MCHV
• Manufacturer: Microchip Technology
• Series: dsPICDEM™r

Specifications of DM330023

• Main Purpose: Power Management, Motor Control
• Embedded: Yes, Other
• Utilized Ic / Part: dsPIC33F
• Primary Attributes: AC Induction (ACIM) Motors, Brushless DC (BLDC) Motors, Permanent Magnet Synchronous (PMSM) Motors
• Secondary Attributes: Power Factor Corrected (PFC)
• Processor To Be Evaluated: dsPICDEM
• Processor Series: dsPIC DSC
• Interface Type: RS-232, USB
• Operating Supply Voltage: 90 V to 265 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

dsPICDEM™ MCHV DEVELOPMENT
SYSTEM USER’S GUIDE
Safety Notice
The safety notices and operating instructions provided should be adhered to, to
avoid a safety hazard. If in any doubt, consult your supplier.
WARNING – This system must be earthed (grounded) at all times.
CAUTION – The system should not be installed, operated, serviced or modified
except by qualified personnel who understand the danger of electric shock
hazards and have read and understood the user instructions. Any service or
modification performed by the user is done at the user’s own risk and voids all
warranties.
WARNING – The output terminals are NOT isolated from the incoming AC mains
supply and may be at up to 410V with respect to ground, regardless of the input
mains supply voltage applied. These terminals are live during operation AND for
five minutes after disconnection from the supply. Do not attempt to access the
terminals or remove the cover during this time.
WARNING – The unit may obtain power through the output terminals if these are
connected to a rotating motor acting as a generator. If this is the case, then the
previous warning also applies (i.e., the output terminals are live when connected
to the generator and for five minutes after the generator has been stopped). Note
that this case can arise even when the unit has been disconnected from the
incoming AC mains supply.
CAUTION – If a motor is connected to the output of this unit, the frame should be
connected to the output protective ground terminal provided. Particular care
should be taken to mechanically guard such a motor, bearing in mind that
unexpected behavior is likely to result from the process of code development.
CAUTION – For continued protection against the risk of fire, replace the fuse with
one of the same type only (i.e., Fast Act Fuse 15A/250 V).
 2009 Microchip Technology Inc.
DS70605A-page iii