STEVAL-IFS006V1 STMicroelectronics, STEVAL-IFS006V1 Datasheet - Page 55

• Manufacturer Part Number: STEVAL-IFS006V1
• Description: BOARD EVAL 8BIT MICRO + TDE1708
• Manufacturer: STMicroelectronics

Specifications of STEVAL-IFS006V1

• Design Resources: STEVAL-IFS006V1 Bill of Material
• Sensor Type: Proximity
• Interface: I²C
• Voltage - Supply: 6 V ~ 48 V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: ST7FLITEUS5, TDE1708
• Processor To Be Evaluated: ST7LITEUS5
• Data Bus Width: 8 bit
• Operating Supply Voltage: 6 V to 48 V
• Silicon Manufacturer: ST Micro
• Silicon Core Number: TDE1708DFT
• Kit Application Type: Sensing - Touch / Proximity
• Application Sub Type: Proximity Switch
• Kit Contents: Board
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Sensitivity: -
• Sensing Range: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-6403; STEVAL-IFS006V1

ST7LITEUS2, ST7LITEUS5
After this startup delay, the CPU resumes operation by servicing the AWUFH interrupt. The
AWU flag and its associated interrupt are cleared by software reading the AWUCSR
register.
To compensate for any frequency dispersion of the AWU RC oscillator, it can be calibrated
by measuring the clock frequency f
Measurement mode is enabled by setting the AWUM bit in the AWUCSR register in Run
mode. This connects f
f
Similarities with Halt mode
The following AWUFH mode behavior is the same as normal Halt mode:
●
●
●
●
Figure 26. AWUF Halt timing diagram
AWU_RC
AWUFH interrupt
f
f
AWU_RC
CPU
The MCU can exit AWUFH mode by means of any interrupt with exit from Halt
capability or a reset (see
When entering AWUFH mode, the I bit in the CC register is forced to 0 to enable
interrupts. Therefore, if an interrupt is pending, the MCU wakes up immediately.
In AWUFH mode, the main oscillator is turned off causing all internal processing to be
stopped, including the operation of the on-chip peripherals. None of the peripherals are
clocked except those which get their clock supply from another clock generator (such
as an external or auxiliary oscillator like the AWU oscillator).
The compatibility of watchdog operation with AWUFH mode is configured by the
WDGHALT option bit in the option byte. Depending on this setting, the HALT instruction
when executed while the watchdog system is enabled, can generate a watchdog reset.
to be measured using the main oscillator clock as a reference timebase.
RUN MODE
AWU_RC
Section 8.4: Active-halt and Halt
HALT MODE
to the input capture of the 8-bit lite timer, allowing the
t
AWU_RC
AWU
and then calculating the right prescaler value.
64 t
CPU
modes).
Power saving modes
RUN MODE
Clear
by software
55/136