STM3210C-EVAL STMicroelectronics, STM3210C-EVAL Datasheet - Page 10

• Manufacturer Part Number: STM3210C-EVAL
• Description: EVAL BOARD FOR STM32F107VCT
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of STM3210C-EVAL

• Contents: Fully Assembled Evaluation Board
• Processor To Be Evaluated: STM32F107VCT
• Processor Series: STM32
• Interface Type: RS-232, USB, I2C, JTAG
• Operating Supply Voltage: 5 V
• For Use With/related Products: STM32F107
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8924

Hardware layout and configuration
2.5
2.6
2.7
Note:
10/52
Audio
The STM3210C-EVAL evaluation board supports stereo audio play by using an audio DAC
CS43L22 connected to both an I2S2 port and one channel of the DAC of microcontroller
STM32F107VCT. The CS43L22 can be configured via the I2C1 bus when JP9 is fitted
(default setting). The automatic switch between the speaker and headphone is performed by
both CS43L22 and the audio jack with plug detection pin.
EEPROM
A 64 Kbit EEPROM connected to the I2C1 bus of STM32F107VCT.
Table 5.
CAN
The STM3210C-EVAL evaluation board supports two channels of CAN2.0A/B compliant
CAN bus communication based on a 3.3 V CAN transceiver. High-speed mode, standby
mode and slope control mode are available and can be selected by setting JP7 for CAN1
and JP8 for CAN2.
JP9 should be kept open for CAN2 to avoid any impact from pull-up on I2C1 bus.
Table 6.
Table 7.
JP17
JP7
JP5
JP8
JP6
Jumper
Jumper
Jumper
CAN1 transceiver works in standby mode when JP7 is set as shown:
CAN1 transceiver works in high-speed mode when JP7 is set as shown:
(Default)
CAN1 transceiver works in slope control mode when JP7 is open.
CAN1 terminal resistor is enabled when JP5 is fitted.
Default setting: Not fitted
CAN2 transceiver works in standby mode when JP8 is set as shown:
CAN2 transceiver works in high-speed mode when JP8 is set as shown:
(Default)
CAN2 transceiver works in slope control mode when JP8 is open.
CAN2 terminal resistor is enabled when JP6 is fitted.
Default setting: Not fitted
The EEPROM is in Write protection mode when JP17 is open. Default setting: Fitted.
EEPROM related jumper
CAN1 related jumpers
CAN2 related jumpers
Doc ID 15082 Rev 3
Description
Description
Description
Configuration
Configuration
1 2 3
1 2 3
1 2 3
1 2 3
UM0600