STM3210C-EVAL STMicroelectronics, STM3210C-EVAL Datasheet - Page 11

• Manufacturer Part Number: STM3210C-EVAL
• Description: EVAL BOARD FOR STM32F107VCT
• Manufacturer: STMicroelectronics
• Type: MCUr

Specifications of STM3210C-EVAL

• Contents: Fully Assembled Evaluation Board
• Processor To Be Evaluated: STM32F107VCT
• Processor Series: STM32
• Interface Type: RS-232, USB, I2C, JTAG
• Operating Supply Voltage: 5 V
• For Use With/related Products: STM32F107
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8924

UM0600
2.8
Note:
RS-232 and IrDA
Both RS-232 and IrDA communications are supported by D-type 9-pin RS-232 connectors
CN6 and IrDA transceiver U12 which connect to USART2 of the STM32F107VCT on the
STM3210C-EVAL evaluation board.
Two signals, Bootloader_BOOT0 and Bootloader_RESET, are added on the RS-232
connector for ISP support.
RS-232 or IrDA are selected by setting JP16.
Table 8.
To communicate with an RS-232 port on a PC, a 9-pin straight RS-232 cable (direct pin to
pin connection) is needed since:
This standard 9-pin straight RS-232 cable is not provided with the board.
Refer to
JP16
JP18
JP19
Jumper
On CN6 the RX signal is connected on pin 2 and the TX data on pin 3,
On the PC side the RX signal is generally on pin 3 and the TX signal on pin 2.
Section 3.6
USART2_RX is connected to RS-232 transceiver and RS-232
communication is enabled when JP16 is set as shown: (Default)
USART2_RX is connected to IrDA transceiver and IrDA communication is
enabled when JP16 is set as shown:
Bootloader_BOOT0 is disconnected from CN6 when JP18 is open.
Default setting: Not fitted
Bootloader_RESET is disconnected from CN6 when JP19 is open.
Default setting: Not fitted
RS-232 and IrDA related jumpers
for details on RS-232 connector pinout.
Doc ID 15082 Rev 3
Description
Hardware layout and configuration
Configuration
1 2 3
1 2 3
11/52