DEMO9S08EL32 Freescale Semiconductor, DEMO9S08EL32 Datasheet - Page 121

• Manufacturer Part Number: DEMO9S08EL32
• Description: BOARD DEMO FOR 9S08 EL MCU
• Manufacturer: Freescale Semiconductor
• Type: MCUr

Specifications of DEMO9S08EL32

• Contents: Evaluation Board
• Processor To Be Evaluated: MC9S08EL32
• Data Bus Width: 8 bit
• Interface Type: RS-232, USB
• Operating Supply Voltage: 12 V
• Silicon Manufacturer: Freescale
• Core Architecture: HCS08
• Core Sub-architecture: HCS08
• Silicon Core Number: MC9S08
• Silicon Family Name: S08EL
• Rohs Compliant: Yes
• For Use With/related Products: MC9S08EL32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

8.3.2
Freescale Semiconductor
EREFSTEN
ERCLKEN
RANGE
EREFS
Field
BDIV
HGO
7:6
LP
5
4
3
2
1
0
Reset:
W
R
ICS Control Register 2 (ICSC2)
Bus Frequency Divider — Selects the amount to divide down the clock source selected by the CLKS bits. This
controls the bus frequency.
00
01
10
11
Frequency Range Select — Selects the frequency range for the external oscillator.
1 High frequency range selected for the external oscillator
0 Low frequency range selected for the external oscillator
High Gain Oscillator Select — The HGO bit controls the external oscillator mode of operation.
1 Configure external oscillator for high gain operation
0 Configure external oscillator for low power operation
Low Power Select — The LP bit controls whether the FLL is disabled in FLL bypassed modes.
1 FLL is disabled in bypass modes unless BDM is active
0 FLL is not disabled in bypass mode
External Reference Select — The EREFS bit selects the source for the external reference clock.
1 Oscillator requested
0 External Clock Source requested
External Reference Enable — The ERCLKEN bit enables the external reference clock for use as ICSERCLK.
1 ICSERCLK active
0 ICSERCLK inactive
External Reference Stop Enable — The EREFSTEN bit controls whether or not the external reference clock
remains enabled when the ICS enters stop mode.
1 External reference clock stays enabled in stop if ERCLKEN is set or if ICS is in FEE, FBE, or FBELP mode
0 External reference clock is disabled in stop
before entering stop
Encoding 0 — Divides selected clock by 1
Encoding 1 — Divides selected clock by 2 (reset default)
Encoding 2 — Divides selected clock by 4
Encoding 3 — Divides selected clock by 8
0
7
BDIV
MC9S08EL32 Series and MC9S08SL16 Series Data Sheet, Rev. 3
Table 8-3. ICS Control Register 2 Field Descriptions
1
6
Figure 8-4. ICS Control Register 2 (ICSC2)
RANGE
0
5
HGO
0
4
Description
LP
0
3
EREFS
0
2
Internal Clock Source (S08ICSV2)
ERCLKEN EREFSTEN
1
0
0
0
121